dimmersensor讨论.pptVIP

Dimmer sensor instroduction 1:基本原理介绍 3:pin define attention: The interrupt Pin:The active low interrupt pin is an open drain pull-down configuration. The interrupt pin serves as an alarm or monitoring function to determine whether the ambient light level exceeds the upper threshold or goes below the lower threshold. It should be noticed that the function of ADC conversion continues without stopping after interrupt is asserted. The REXT pin:The ISL29023 uses an external resistor REXT to fix its internal oscillator frequency, fOSC and the light sensing range, Range. fOSC and Range are inversely proportional to REXT. for user simplicity, the proportionality constant is referenced to 500kΩ 4:optical design Flat Window Lens Design A window lens will surely limit the viewing angle of the ISL29023. The window lens should be placed directly on top of the device. The thickness of the lens should be kept at minimum to minimize loss of power due to reflection and also to minimize loss of loss due to absorption of energy in the plastic material. The recommended angle are 35°45° Window with Light Guide DesignIf a smaller window is desired while maintaining a wide effective viewing angle of the ISL29023, a cylindrical piece of transparent plastic is needed to trap the light and then focus and guide the light on to the device. Hence, the name light guide or also known as light pipe. The pipe should be placed directly on top of the device with a distance of D1 = 0.5mm to achieve peak performance. The light pipe should have minimum of 1.5mm in diameter to ensure that whole area of the sensor will be exposed. 5:Typical Performance Curves Sun light ; halogen ; fluoresent; infrared * Photodiode(2pcs) Light Convert light to current Convert current to digital by a built-in 16 –bit analog-to-digital(ADC) An I2C command reads the ambient light or IR intensity in counts 2：内部原理图 Spectrum of Four Light Sources Spectral Respones for Ambient Light Sensing Sensitivity to four light