不发火耐磨地面施工方案.docVIP

不发火耐磨地面施工方案 Implementation of Schemes 实施一：确定调节高度螺栓的形式及位置 Implementation 1: Confirm form and location of the bolt for adjusting elevation 江都仔细分析了高度调节的过程，制定了调节高度螺栓的形式。即在Φ14螺栓头部设置两个丝帽，将角铁夹在两个丝帽中间，下部丝帽调节高度，上部丝帽固定角铁，调高螺栓的位置及标高要依据对图纸地面坡度的计算，如下图： Jiangdu carefully analyzes the process of adjusting elevation and formulates the form of bolt for adjusting elevation. Namely, install two screwed caps at the head part ofΦ14 bolt, make angle iron clamped between two screwed caps, the screwed cap underneath is used for adjusting elevation, the screwed cap of upper part is used for fixing angle iron, location and elevation of the bolt for adjusting elevation must be calculated in line with ground slope on the drawing, shown as the figure below: 实施二：确定角铁及其支撑点的间距 在充分考虑了L30角铁的刚度性能及材料的用量后，决定在6m长的角铁上间距1900mm设置支撑点。如下图： 实施二：确定角铁及其支撑点的间距 Implementation 2: Confirm the gap between angle iron and support point 在充分考虑了L30角铁的刚度性能及材料的用量后，决定在6m长的角铁上间距1900mm设置支撑点。如下图： After full consideration of stiffness performance and materials dosage of L30 angle iron, the support point is determined to set on the angle iron with the length of 6m every 1900mm gap, shown as the figure below: 结合施工人员操作方便，确定角铁间距为5.4m。如下图： Combined with operational convenience of construction personnel, the gap between angle iron is determined to be 5.4m, shown as the figure below: 实施三：制定调解螺栓的固定方式 Implementation 3: Formulate fixing method of adjustable bolt 在垫层上放样，然后采用Φ12钻头按放线位置进行钻孔，再将Φ14调节螺栓钉入砼垫层内。施工时，如有松动，则在螺栓与孔的缝隙内钉入铁钉进行加固。 Loft on the bedding, and then take advantage ofΦ12 drill to drill holes according to line setting out position and hammerΦ14 adjustable bolt into concrete bedding. During construction, if any loose status occurs, the iron nail will be hammered into the gap between bolt and hole for reinforcement. 实施四：采用水准仪对角铁确定标高 Implementation 4: Take advantage of leveling instrument to confirm elevation of iron 施工中，由技术员采用C32Ⅱ型水准仪对角铁进行标高确定，同时，施工人员根据技术员的指令调节调节螺母，将角铁的高度调节好，校核无误后，将固定螺母拧紧。标高确定过程中，每个调节点都仔细校准标高。如下图： Du