am60命令小结.docVIP

armcfg: 1 Bind a LUN 1 Unbind a LUN 2 Change LUN Ownership 2 Replace a LUN 3 armmgr: 3 Add a Hot Spare 3 Remove a Hot Spare 3 Set the Cache Page Size 3 Assign an alias to a disk array 4 Set on one controller; automatically syncs the second controller 4 Change controller state from passive to active 4 Synchronize the controller date and time with the host 4 Reset battery age to zero when the battery is replaced 4 Perform a parity scan on a LUN 4 amutil: 4 Disable Disk Write Cache (WCE) 4 Locate a disk module by flashing its amber LED 4 Flush (retrieve) disk array controller’s event logs 4 Change a disk’s state by manually failing the disk 4 Hardware States control 4 amdload: 5 amdsp: 5 Disk Array Status Commands 5 Rescan for all disk arrays on the host 5 List all disk arrays recognized by the host 5 Check the status of the rebuild process 5 Identify disks 5 amlog: 5 armcfg: Bind a LUN amcfg -L cntrlrID:LUN -d channel:ID,channel:ID … -r RAIDlevel options ArrayID where: cntrlrID Identifies the controller (A or B) that will own the LUN LUN Number assigned to the LUN channel:ID Identifies the channel and SCSI ID of each disk,in the LUN Multiple disks must be entered without spaces between disk identifiers RAIDlevel RAID level to be used for the LUN, Valid values are 1 and 5 A RAID 0/1 LUN is created by selecting RAID 1 with a even number of more than two disks options -c capacity Capacity of the LUN in M (megabytes) or G (gigabytes) Default is entire capacity of disk modules If M or G are not specified, default is G -force Overrides the HA protection that prevents using two or more disks in the same SC10 or on the same channel options -s stripe Stripe segment size in Kbytes Must be a multiple of the current cache page size setting Default is the same block size used for cache pages, either 4 or 16 Kbytes ArrayID The FC60 serial number or alias Example of command for binding a 5-disk RAID 5 LUN onan FC6