触控极光-单片机设计报告-twbin.docVIP

摘 要 利用C语言编程方法，结合在《单片机原理及接口技术》课程中学到的知识。论文从项目开发的硬件到设计思路到程序设计做了一个完整的论述。 单片机自问世以来，以其极高的性能价格比，受到人们的重视和关注，应用很广、发展很快而51单片机是各单片机中最为典型和最有代表性的一种。?本设计以STC15W413AS芯片为核心，辅以必要的外围电路，制作了一个简易的极光，它由5V直流电源供电。在硬件方面，除了CPU外，使用28个三色LED灯来进行显示，通过显示不同的颜色以及不同颜色的混合来展现不同的形态。一个简单的触摸按键实现对显示效果的切换。软件方面使用K进行C语言编程。最终让整个极光系统能完成各色变换，流水灯等功能。 Abstract The combination use of C language programming method, the single chip microcomputer principle and interface technology course to learn knowledge.Papers from the design of hardware to the project development to expound a complete program design. Since the advent of MCU, with its extremely high cost performance, is peoples attention and concern, application is very wide, developing very quickly.And 51 single-chip microcomputer is the most typical in the single chip microcomputer and one of the most representative.This design STC15W413AS chip as the core, supplemented by necessary peripheral circuit, made a simple aurora, it consists of 5 v dc power supply.In terms of hardware, in addition to the CPU, using 28 three color LED lights to show, by showing different colors and different colors of mixed in different forms to show.The touch of a simple button to display the switch.Software using Keil uVision4 software with C language programming.Finally let the aurora system can accomplish various transformation, water lights, and other functions. In this design, strictly in accordance with the first to be familiar with the hardware architecture, in making the program flow diagram, the last to write programs, this greatly avoid the unnecessary trouble. Through this design make us more insight into the basic circuit of SCC, and how the basic methods of timer control and interruption programming, so as to exercise our learning and the ability of the hardware and software design and development.目 录 摘 要 I Abstract I 目 录 1 1 单片机课程设计的目的和意义 1 2设计任务与总体设计思路 1 2.1 设计要求 1 3硬件电路设计 2 3.1 STC15W413AS简介 2 3.2 模块设计 3 3.3 硬件电路图 4 4 软件设计 4 4.1设计思路与流程图 4 4.2 关键程序 5 5 问题分析与解决