仪用放大器的分析.docVIP

目 录 摘 要 ………………………………………………………………………………………… 2 引 言 ………………………………………………………………………………………… 3 1 集成运算放大器 ……………………………………………………………………… 4 1.1 集成运算放大器的介绍 ……………………………………………………………… 4 1.2 理想运算放大器工作在线性区的特点…………………………………………… 4 1.3 集成运放的使用和保护方法………………………………………………………… 6 1.4 集成运放的性能指标…………………………………………………………………… 2 基本仪用放大电路……………………………………………………………………… 8 2.1比例运算电路 ………………………………………………………………………… 8 2.2 具有差动输入的前置放大级仪用放大电路 ……………………………………… 10 3 实用特殊仪用放大电路 …………………………………………………………… 13 3.1 低噪声仪用放大电路 ……………………………………………………………… 13 3.2 高精度、高祖抗仪用放大电路 ……………………………………………………… 13 3.3信号浮动的仪用放大电路…………………………………………………………… 17 4 直流稳压电源…………………………………………………………………………… 18 4.1稳压电源的工作原理……………………………………………………………… 18 4.2 变压器的选择……………………………………………………………………… 19 结 论 ……………………………………………………………………………………… 21 致 谢 ……………………………………………………………………………………… 22 参考文献 …………………………………………………………………………………… 23 附 录 …………………………………………………………………………… 摘 要 通过查阅大量有关放大器的书籍和有关网页，掌握了放大器的工作原理，熟悉了电路的基本构造和功能。在很多电子系统中都需要对输入的模拟信号进行检测。由于在其传感器接口电路中常采用差分输入方式，因而在系统的两个输入端难免会引入共模干扰信号，且该共模干扰电压一般都比较大，这种干扰信号在信号输入电路参数不对称时会转化为差模干扰并对测量系统产生影响，其影响的大小直接取决于共模干扰转换成差模干扰的大小。本文探讨利用少量辅助电路与高精度集成芯片组成测量误差很小的仪器用放大电路,分析这类电路,有利于提高实用电子电路的性能.,因而,具有较高的理论价值和实际意义. Abstract: In the electronic information system, the signal gathered through the sensor or other ways is often very small, and it cant make operation ;strain wave etc. In order to deal with directly , the signal must be enlarged . In addition, it is often the mould signal that the sensor obtains and contains bigger part of the mould altogether, its number value is long-range and sometimes it is different from mould signal. So the circle requires the amplifier to have ability to have stronger restrain to the signal of the mould altogether. And with the development of science and technology, various kinds of electronic equipment requires higher and higher to the precision which measures the instrument and apparatus , the ordinary integrated amplifier cant already satisfy the demand . To solve this question , this design have originally carr