导线捆扎.doc

Cable lacing（导线捆扎） 编号：02-MULT-07 General description…………………………………………………...1 Single ties…………………………………………………………….1 Double-cord lacing……………………………………………………6 Intervals for wire harness ties…………………………………………9 Tie materials…………………………………………………………..9 Note……………………………………………………………………9 Plastic Tie Strap Wire Harness Ties………………………………….10 Wire harnesses with coax cable……………………………………… 11 General description Two types for wire harness ties: Lacing tapes Plastic tie straps Single-cord lacing: use for cable bundles 1 in. (2.54cm) in diameter or less. Double-cord lacing: require for large cable bundles. 2. Single ties: 2.1 Description: A tie has two knots A clove hitch knot A square knot or a surgical knot 2.2 Procedure: 2.2.1 Method(A): not in the high vibration area The locked clove hitch is used. The clove hitch is formed and it is then locked with a square knot. Step 1: Step 2: Method(B): Make ties on high vibration or excessive heat area. Vibration Level Type 1 Not a high vibration area 2 A high vibration area 3 A high vibration area Step to make a clove hitch knot on the high vibration area. Complete the clove hitch on the harness and make sure that the knot is tight. Step 1: make a clove hitch on the harness. Make sure that the knot is tight. Step 2: A square knot or a surgical knot is used to prevent the unwanted movement of a clove hitch on the harness. Step 3: Cut the two ends of the material so that the distance between the ends of the materials is 0.25 in. to 0.5 in. 3. Double-cord lacing 3.1 Description Use for large cable bundles. The method is basic the same to the single-cord lacing. 3.2 Procedure 3.2.1 Method (A): Step one: The first loop is made with a special type of slip knot similar to the “bowline-on a bight”. Step two: Make a square knot or surgical knot on top of the clove hitch knot. Step three: The free end of the lacing cord should be trimmed to approximately 3/8 in. (0.95cm). 3.2.2 Method (B): Tie a square knot. 4. Intervals for wire harness ties