电网谐波治理和无功补偿技术的分析-测试计量技术及仪器专业论文.pdf.docxVIP

AbstractAt present, because more and more power electronic equipments are used in the power system, which cause the harmonic pollution of power system getting worse and worse, meanwhile a great many reactive power is cost. The active power filter has a good performance in the compensation of dynamic harmonic current, which can meet the harmonic and the reactive current at the same time, so more and more attention is paid to it. This paper is just the study of the compensation of the harmonic and the reactive current for the active power filter.Firstly, this paper describes the work principle of the shunt active power filter and establishes the mathematical model according the switch function. Then, do the research of the detection method of harmonic and reactive current. The accuracy and the real-time have an important effect on the compensation effect. Based on the reactive power theory, the traditional current detection method has been proposed in the paper. Due to the error exist in the situation of asymmetric voltage, an improved method of detecting harmonic and reactive current has been used. The theoretical analysis and simulation study shows the possibility of detecting the harmonic and reactive current accurately. Again, in the current control of APF, combined with the advantages between the space vector control method and hysteresis current control, the hysteresis current control method based on optimal voltage space vector is used, the method has a good dynamic response speed, also reduce the switch frequency. The compensation effect is good.The paper design the system hardware circuit by using the DSP(TMS320F2407)as the control chip, analysis from the main circuit and control circuit and also draw the flow chart of the main part of the software in system. Finally, modeling the entire system according MTALAB7.0, the simulation results show that the designed system meets the requirements of harmonic and the reactive current compensation.Keywords: harmonic a