1ATM高级刀具管理.pptVIP

LET’S TAKE A LOOK AT HOW THIS DISPLAY CAN BE USED Duplicate or backup tools can be classified into specific groups. The programmer specifies a group of tools instead of a single tool in the G-code program. ATM will track the usage of individual tools in each tool group and compare it to user defined limits. Once a limit (e.g. number of holes drilled or tool load) has been reached, the mill will automatically choose one of the other tools in the group the next time that the tool is needed. Programming T1234 M06; (Calls up a tool in group 1234) G43 H1234 Z1.0 (Sets the tool length offset for the tools in group 1234) #8001 = 1 (Expires tool 1) #8001 = 0 (Makes tool 1 available if expired manually or with macro) The Macro statements can only be used with the macro option. Macros 8001-8200 represent tools 1-200. * Advanced Tool Management Information Module Using the Advanced Tool Management Display In the HAAS CONTROL Press WRITE/ENTER to display The previous tool group’s data. PRESS THREE TIMES TO GET TO THIS PAGE If VQC Probing Is not selected SLIDE LEGEND UPPER CASE (WHITE) - ACTION YOU WILL TAKE UPPER CASE (ORANGE) - INSTRUCTIONS KEYS 0N THE CONTROL UPPER AND LOWER CASE (BLUE) - INFORMATION The ADVANCED TOOL MANAGEMENT Display Improves on operator’s capability to monitor and control tool life Allows grouping of tools to facilitate lights out machining Available starting in Software version 13.4 Activated by Parameter 315 PRESS TOENTERCURRENT COMMANDS DISPLAYS PRESS UNTIL YOU REACH THE ADVANCED TOOL MANAGEMENT SCREEN In the upper left is the “TOOL GROUP” window. In the lower right, there is a help dialog. Press WRITE/ENTER to display The previous tool group’s data. PREVIOUS PRESS TWICE To ADD You can now enter the number of a new Tool Group for a particular tool The number must be between 1000 and 2999. Enter a four digit number and press WRITE/ENTER to create a new tool Group. ADD ENTER 1234 and PRESS