本科毕业论文外文翻译--单级单刀功率因数校正器AC-DC变换器.docVIP

电子与信息工程学院 本科毕业论文(设计) 外 文 文 献 翻 译 译文题目：single-stage single-switch powerfacter correction AC/DC converter 学生姓名： 专 业： 指导教师： 2010年 3 月 原文， Single-stage single-switch power factor correctionAC/DC converter Abstract A single-stage single-switch power factor correction AC/DC converter is proposed in which the power factor correction (PFC) inductor is connedted to a tap on the primary winding ofthe DC/DC flyback converter stage; there is direct energy transfer of a part of the input energy tothe output and theDC-bus voltage feedback. The additional discharge path in the PFC inductorand DC-bus voltage feedback effectively suppresses the DC-bus voltage and increases the overallefficiency. Experimental results for a 60W converter at a constant switching frequency of 70 kHzare obtained to show the performance of the proposed converter. It is shown that the voltageacross the DC-bus capacitor can be held below 405V even though the converter operates in a widerange of input voltages (90V-265VAC) and the measured input current harmonics satisfy the IEC。 1 Introduction Many PFC AC/DC converters have been presented inrecent years. PFC techniques can be divided into twocategories: a single-stage approach and a two-stageapproach. The two-stage approach is the most commonlyused approach. Conventional two-stage PFC convertersinvolve the use of cascading two power-processing stages,responsible for power factor correction and output voltageregualtion. A PFC converter is adopted at the front-end toforce the line current tracking the line voltage and anotherconventional DC/DC converter is cascaded after the PFCstage to obtain the desired tightly regulated output voltage.This approach can obtain very good performance, such ashigh power factor, and low voltage stress. However, due tothe use of two power-processing stages, conversionefficiency is reduced and an additional PFC stage addscomponents and complexity. Consequently the overall cos