思科Catalyst3000x系列技术手册.pptVIP

* * Flexstack bw is given for single switch only * * As an example Uplink encryption modules to fully support CTS. Classification is used to determine how much power is required by the PD. This was an optional step for legacy systems. If classification was omitted, the legacy PSE was require the maximum power the standard supported. Legacy devices are now referred to as Type 1 devices. Type 1 device could perform a one event classification. The PSE provides a classification voltage and measures the current the PD sinks. A Type 1 PD may continue to provide it detection resistance. This is interpreted as a default class-0 power level. New PoE plus devices are referred to as Type 2. Type 2 PDs may provide class 4 in order to obtain more than legacy power levels. Type 2 PSEs may use a new 2 event classification probe or the legacy 1 event classification. The labels used within the voltage ranges show how a PD responds during 2 event classification. The mark range exists so that the PD circuits can remember that a class event occurred. Type 1 PSE Optionally classify a PD using 1-event physical layer classification Class 0, 1, 2, and 3 No classification, default 0 (15.4W) Optionally implement LLDP classification Type 2 PSE ONLY 1-event Physical layer classification and Data Link Layer classification is Supported on Incredibles. No 2-event Physical layer classification (Mid-spans only) No 2-event Physical layer classification and Data Link Layer classification * * JM: HW has built-in capability to allow IOS to override fan speed but not implemented. The following efficiency requirements are inclusive of internal fan power consumption?. Referencing the chart table below, the power supply shall be minimum 80% efficient at 10% load. Efficiency minimum shall increase linearly from 80% to 89% efficient between 10% load to 25% load. From 2