Cisco IPv6课程.pptVIP

Cisco IOS Software Is IPV6-Ready: Cisco IOS Dual Stack If both IPv4 and IPv6 are configured on an interface, this interface is dual-stacked. Dual stack is an integration method where a node has implementation and connectivity to both an IPv4 and IPv6 network. Dual Stack Cisco IOS Software Is IPv6-Ready: Overlay Tunnels Tunneling encapsulates the IPv6 packet in the IPv4 packet. Tunneling Tunneling is an integration method where an IPv6 packet is encapsulated within another protocol, such as IPv4. This method of encapsulation is IPv4 protocol 41: This method includes a 20-byte IPv4 header with no options and an IPv6 header and payload. This method is considered dual stacking. “Isolated” Dual-Stack Host Encapsulation can be done by edge routers between hosts or between a host and a router. Cisco IOS Software Is IPv6-Ready: Configured Tunnel Configured tunnels require: Dual-stack endpoints IPv4 and IPv6 addresses configured at each end IPv6 隧道 /24S1/0 /24S1/1 S1/0/242001:AB1:0:2::2/64 2001:AB1:0:9::1/642001:AB1:0:A::1/642001:AB1:0:B::1/642001:AB1:0:C::1/64 2001:AB1:0:3::1/64 ipv6 unicast-routing!interface tunnel 0 ipv6 address 2001:ab1:0:2::1/64 tunnel source serial 1/1 tunnel destination  tunnel type ipv6ip!ip route ipv6 route 2001:ab1:0:3::/64 2001:ab1:0:2::2 ipv6 unicast-routing!interface tunnel 0 ipv6 address 2001:ab1:0:2::2/64 tunnel source serial 1/0 tunnel destination  tunnel type ipv6ip!ip route ipv6 route 2001:ab1:0:1::/64 2001:ab1:0:2::1 R2 IPv4Network IPv4Network R3 R1 2001:AB1:0:2::1/64/24S1/1 IPv6Network IPv6Network Cisco IOS Software Is IPv6-Ready: 6to4 Tunneling 6to4 Is an automatic tunnel method Gives a prefix to the attached IPv6 network 6to4的配置 interface Loopback0 ip address //全球单播地址，要求可路由 interface Tunnel1 ipv6 address 2002:202:202::2/64//这个地址是单播的转换出来的，跟源地址有关,前缀是2002加上ipv4 转换出来的十六进制 0202 0202 ,后面的地址自己随意指定 tunnel source Loopback0 tunnel mode ipv6ip 6to4 //选择模式是ipv6ip 6to4 ipv6 route 2002::/16 Tu