Machine guarding- 机械安全防护.pptVIP

* Image: Worksafe BC /i/posters * Image: Worksafe BC /i/posters Machine Safety Responsibilities Management Ensure all machinery is properly guarded Supervisors Train employees on specific guard rules in their areas; Ensure machine guards remain in place and are functional; Immediately correct machine guard deficiencies Employees Do not remove guards unless machine is locked and tagged; Report machine guard problems to supervisors immediately; Do not operate equipment unless guards are in place Proper training should address: Hazards associated with particular machines How the safeguards provide protection and the hazards for which they are intended How and why to use the safeguards How and when safeguards can be removed and by whom What to do if a safeguard is damaged, missing, or unable to provide adequate protection Deaths attributed to Inadequate Guarding from MSHA files On July 21, 2005, a 31-year old plant operator with two years mining experience was fatally injured at a sand and gravel operation. The victim made a splice on a conveyor belt and was making adjustments to the belt. He was found entangled in the tail pulley of the conveyor. On February 7, 2002, a 37-year-old male laborer (the victim) was fatally injured when he became caught between a conveyor belt and an idler pulley of a rock crushing machine. The victims job consisted of sweeping and shoveling the area around the rock-crushing machine. Approximately 20 minutes after the victim arrived at work he was found underneath the rock crushing machine with his arm caught between a conveyor belt and an idler pulley. The victim was caught by one of the rock crushing machines conveyor belts and an idler pulley. The location of the victim was underneath the machine near the electrical panel. Hazard analysis of equipment prior to use. Employee task training. Proper guarding. Installation of pull cable emergency stops that surrounds the entire machines perimeter inst