- 1、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。。
- 2、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载。
- 3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
- 4、该文档为VIP文档,如果想要下载,成为VIP会员后,下载免费。
- 5、成为VIP后,下载本文档将扣除1次下载权益。下载后,不支持退款、换文档。如有疑问请联系我们。
- 6、成为VIP后,您将拥有八大权益,权益包括:VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
- 7、VIP文档为合作方或网友上传,每下载1次, 网站将根据用户上传文档的质量评分、类型等,对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档
查看更多
毕业设计论文-酸法制绒下减薄量对多晶硅太阳能电池片电性能的影响
酸法制绒下减薄量对多晶硅太阳能电池片电性能的影响摘 要
多晶硅太阳能电池的出现在很大程度上降低了材料的制作成本,然而其光电转换效率并没有单晶太阳电池的高。其中主要有两个原因:一方面是由于多晶硅材料具有晶界、高密度的位错、微缺陷和相对较高的杂质浓度,降低了有效少数载流子寿命;另一方面,多晶硅片表面的陷光效果要比单晶硅差,不能很好地吸收和利用太阳光。
本实验采用酸法制绒工艺,通过控制多晶硅片的减薄量,研究绒面大小对多晶太阳能电池片电性能的影响,进而确定工艺参数提高太阳能电池片的光电转换效率。结果表明:减薄量在0.35-0.4时电池片的串并联电阻均最小,反射率最低,但由于此时的漏电流最大,使得最终光电转换效率低于理论值; 减薄量控制在在0.4-0.45时,多晶硅太阳能电池片的串并联电阻较小,但此时的漏电流和反射率较小,使得多晶硅太阳能电池片的开路电压和短路电流达到最大,光电转换效率最高为15.7664%;减薄量在0.45-0.5g时,多晶硅太阳能电池片的串并联电阻均为最大,且反射率最高,使得最终光电转换效率最低。
关键词:多晶太阳能电池片,酸法制绒,减薄量,光电转换效率,漏电流,反射率
The Influence of Corrosion Quantity to the Multi-crystalline silicon cellsPerformance under the Acidc Ecth
ABSTRACT
Multi-crystalline silicon solar cells have greatly reduced the production cost of materials when It is appeared,but its eff is not higher than mon-crystalline silicon solar .there are two main reasons:on the one hand Multi-crystalline silicon has grain boundaries、high-density dislocation、Micro-defects and relatively higher impurities density,which reduced effective minority carriers life.On the other hand ,Multi-crystalline silicon wafer surface of sink light effect is worse than mon-crystalline silicon.
The experiment using acid corrosion process,through the control of multi-crystalline silicon wafers corrosion quantity ,researches how the suede size influence the multi-crystalline silicon cellsperformance,then determine process Parameters to improve solar-cells photoelectric conversion efficiency.
The results show that:when the corrosion quantity is between 0.35g and 0.4g, Rs and Rsh are both minimum, the reflctivity is lowest ,but the Irev is maximum,so the photoelectric conversion efficiency is lower than theortical.when the corrosion quantity is controled between 0.4g and 0.45g,The Rs and Rsh are both lower than the former,but the Irve and reflectivity are both smaller,so that the Uoc and Isc of the multi-crystalline silicon cells both reached maximum and the highest photoelectric conversion efficiency is 15.7664%. when the corrosion quantity is controled
文档评论(0)