分布式智能与储能技术在智能配电网中的应用.ppt

Here’s the general arrangement of components on a 25-kV Scada-Mate CX Switch in the Upright Mounting Configuration. This switch includes optional SC Current/Voltage Sensors on the pole-saddle side. The switch is factory-assembled on a one-piece base and includes an integral stored-energy operating mechanism. Each interrupter is operated by a rotating insulator mounted at the front terminal pad end. In addition to electrically operating the interrupters, the operating mechanism provides non-electrical mechanical opening and closing of the interrupters by means of a manual-operation pull-ring. I want to discuss two products that SC has which address the “Substation” and “Edge of the Grid” spaces on slide 8. The SMS can be provided in containers of 4 MW and those can be paralleled to make larger systems, with a practical limit of 30 to 40 MW The CES is currently under development and will be deployed first in AEP’s Ohio GridSMART, DOE funded program. We have a pretty extensive resume of projects. click I’ll be talking about the features and benefits of these projects and about Community Energy Storage. IntelliTeam SG 重要特征七 —— 新的正常运行方式 若一次接线系统的正常运行方式有所改变，仅需进行以下 的操作： 在IntelliTeam Designer设计软件窗口中画出新的正常运行方式下的系统单线图; 通过通信系统，将IntelliTeam Designer设计软件与系统中的任一设备连接起来; 根据IntelliTeam Designer设计软件的提示逐一完成系统所有设备的配置 其它应用 — 孤岛效应 用于接有电能储存系统的配电系统 IntelliRupter智能脉冲式重合器 配电领域内极具革命性创新的智能保护产品 设计先进 精确的传感系统、一二次一体式结构; 独特的脉冲关合技术，用户可根据需 要设定脉冲检测次数; 和间隔 触头合分一次仅3-8ms; WiFi、GPS、光纤或无线; 切除故障总时间不超过35ms; 安全性高，高度智能化系统; 现场直接吊装，无任何外接部件， 完全免维护 注入的能量对比示意图 故障电流(A) 脉冲式重合器 传统重合器 脉冲关合 电源侧电压特定相位角(118度)关合 快速的合-分操作,注入能量小:脉冲时间为3~8ms 脉冲关合操作始终有 一个合-分操作: 分析脉冲信号, 然后判断 故障。将脉冲信号发出后 的返还数据与数据模型库 中已存4万次试验结果状况 比较，确认是否有故障。 不同合闸角度下的脉冲比较 —— 90° 不同合闸角度下的脉冲比较 —— 0° 不同合闸角度下的脉冲比较 —— 118° 脉冲关合--AB相间永久故障 Test 1 Test 2 Initial Trip 电源侧电压118度角时合闸，3-8ms内分闸。 Phase C (A) Phase B (A) Phase A (A) 非故障电流脉冲 Fault-Pulses 故障电流脉冲 可排除励磁