主機操控系統.pptVIP

P TYPE MAIN ENGINE REMOTE CONTROL CONTROL SAFETY AIR LINE (A). 0.8MPa Air 由AO →117HB →A1 →36HB → →342HA →A3 →287HA (0.8MPa Control) →342HE →A4 →287HB (0.7MPa Safety). (A-1). 287HA →126HA (PRE-CYL.LUBRICATION) . →D1 →53HI ~ HL.(FP. Fuel Cam not in End POS. Device) →3.05 VIT P1 →E8 →115HD →31HA(Turnin Gear Disengaged) →E6. (A-2). 287HB →6.04 (Over Speed and Safety Shut Down). →VIT P2. →E7 →115HD →Back up Control Air for Start/AH /AS → 31HC ####### ########當3.12 Emergency Control Level not in R.C. POS.####### 287HB →31HC → 53HC 切斷3.10 Fuel Air CYL. →49HH當E/S操俥時,REVERS.SERVOM. Not in POS. or EM. Stop →38A~D →6.04 將FP. Suction Valve closed使 M/E 停俥. (B). 25MPa Air →A2 →36HC →117HA →19HA (降壓→7.0MPa) →342HB →36HA →A6 →4.06作為EXH. V.的 Spring Air . (B-1). 如果Air Spring低壓故障則4.09自動激磁,使1與2 port通, 則Control Air由342HA →4.09 →342HF →36HA →A6 →4.06待Air Spring正常後按 Reset . (B-2). 若4.09也故障則可將4.10(手動閥)開啟 Spring Air 仍可由 342HA →4.10 →36HA →A6 →4.06 . REVERSING AHEAD ASTERN Control Air 0.8MPa 由287HA →E8 →115HD →E9 →31HA (2.13 Turning Gear) →E6 . (A). AHEAD: 130HD (1→2) →49HD →E4 →2.22 (Pilot Air Distributor Servo Piston)上方 →212HA (port 5). →130HF (port 1). →推動5.02 (Fuel Cam reversing servo motor in “AHEAD” End Position). (B). ASTERN: 130HE (1→2) →49HE →E5 →2.22 下方 →212HA (port 5). →130HF (port 1). →推動5.02 (Fuel Cam reversing servo motor in “ASTERN” End Position). REVERSING AHEAD ASTERN 5.02 Fuel Cam reversing servo motor in “AH”OR“AS” End Position). 則Cross Head L.O.1~1.2MPa →6.01 Revers. Servom. →B6 →216HB (PIN凸出) →53HB (使1→2不通). (A).若5.02或2.22 /6.01不正常則無油壓作動53HB . 則Air由 B5 →53HB (1→2) →B7 →G11 →115HC (P2→A). →141HB 使ACTUATOR 歸零. (B).若各缸 FP 5.01不正常則滑油無法作動216HI~HK等. 則AIR將由D1 →53HI →113HA →D2 →53HK →113HB →D2 →D3 →113HA