chap15 Bluetooth Techniques 无线网络通信 英文教材.pptVIP

LMP PDUs General response Security Service Authentication Pairing Change link key Change current link key Encryption LMP PDUs Time/synchronization Clock offset request Slot offset information Timing accuracy information request Station capability LMP version Supported features LMP PDUs Mode control Switch master/slave role Name request Detach Hold mode Sniff mode Park mode Power control LMP PDUs Mode control (cont.) Channel quality-driven change between DM and DH Quality of service Control of multislot packets Paging scheme Link supervision L2CAP Provides a link-layer protocol between entities with a number of services Relies on lower layer for flow and error control Makes use of ACL links, does not support SCO links Provides two alternative services to upper-layer protocols Connection service Connection-mode service L2CAP Logical Channels Connectionless Supports connectionless service Each channel is unidirectional Used from master to multiple slaves Connection-oriented Supports connection-oriented service Each channel is bidirectional Signaling Provides for exchange of signaling messages between L2CAP entities L2CAP Packet Fields for Connectionless Service Length – length of information payload, PSM fields Channel ID – 2, indicating connectionless channel Protocol/service multiplexer (PSM) – identifies higher-layer recipient for payload Not included in connection-oriented packets Information payload – higher-layer user data Signaling Packet Payload Consists of one or more L2CAP commands, each with four fields Code – identifies type of command Identifier – used to match request with reply Length – length of data field for this command Data – additional data for command, if necessary L2CAP Signaling Command Codes L2CAP Signaling Commands Command reject command Sent to reject any command Connection commands Used to establish new connections Configure commands Used to establish a logical link transmission contract between two L2CAP entities L2CAP Signaling Comman