ChainDriveNew 机械设计 英文PPT教案_重大培训资料.pptVIP

Chain Drives(链传动);Power transmission chains can be categorized as Roller chain Silent chain Engineering steel chain Detachable chain.;pins that pivot inside the roller bushings. pins are press fitted into the pin link plates roller bushings are press fitted into roller link plates free-turning roller encircles each bushing to provide rolling engagement and contact with sprocket teeth;2.Joints (联接链节);3.滚子链的规格 ;Where the transmission of high power is the primary requirement, engineering steel drive chains offer many useful solutions.;Advantages detachable links can be separated at any joint without using special tools Detachable chain is low in cost and can transmit up to 25 hp at speeds to 350 fpm. ;Chordal action (弦切现象或多边形效应);二、瞬时速度和瞬时传动比;　　当主动链轮匀速转动时，从动链轮的角速度以及链传动的瞬时传动比都是周期性变化的，因此链传动不宜用于对运动精度有较高要求的场合。;?d=?p/sin(180?/z) ;通常限制链传动的传动比i≤6，推荐的传动比i＝2~3.5。 ;Advantages of chain drives over belt drives are:;Drawbacks of chain drives that might affect drive system design are:;Coiler drive;Shaft center distance;Very long center distances cause excessive tension and may cause the chain to jump teeth. Long chains may need to be supported by guides or idlers.;链传动的合理布置;Allowable Power for roller chain 链传动的承载能力 ;2.A系列套筒滚子链的实用功率曲线图;Ⅰ—人工定期润滑　　Ⅱ—滴油润滑 Ⅲ—油浴或飞溅润滑　　Ⅳ—压力喷油润滑 ;三、链传动主要参数的选择 ;例10-2 设计如图10-31所示的带式运输机传动方案中的滚子链传动。已知小链轮转速n1=123r/min，传动比i=3，传递功率P＝6.85kW，两班制工作，中心距可调节，载荷平稳。 ;解： 1．选定链轮齿数z1、z2;该链条在实验条件下所需传递的功率 ;6.链条型号：20A–1×122 GB1243.1–83;　　链传动在安装时，应使链条受到一定的张紧力，张紧的目的主要是使松边不致过松，以免影响链条正常退出啮合和产生振动、跳齿或脱链现象。 ;　　作用在轴上的载荷FQ可近似地取为主动边和从动边总拉力之和，因离心拉力不作用在轴上，不应计算在内，由此得FQ=F+2Ff。又由于垂度拉力不大，故可近似取