锅炉停炉期间的保养措施boiler maintenance method while stopping.docVIP

锅炉停炉期间的保养措施boiler maintenance method while stopping.doc

  1. 1、本文档共2页,可阅读全部内容。
  2. 2、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
  3. 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载
  4. 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
  5. 5、该文档为VIP文档,如果想要下载,成为VIP会员后,下载免费。
  6. 6、成为VIP后,下载本文档将扣除1次下载权益。下载后,不支持退款、换文档。如有疑问请联系我们
  7. 7、成为VIP后,您将拥有八大权益,权益包括:VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
  8. 8、VIP文档为合作方或网友上传,每下载1次, 网站将根据用户上传文档的质量评分、类型等,对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档
查看更多
锅炉停炉期间的保养措施boiler maintenance method while stopping

锅炉停炉期间的保养方法 boiler maintenance method while stopping 机组酸洗、吹管结束后,局限于系统恢复、设备缺陷处理及安装工作正在进行中,采取热炉放水预热烘干法进行了保护。待上述相关工作结束后,应按照机组停运的时间长短,依据《火力发电厂停(备)用热力设备防锈蚀导则》SD 223—87的要求,采取相应的防锈蚀方法进行机组的保护。Because system recovery, equipment defects and erection work are going on after Unit acid clean and steam blowing, take discharge from hot boiler, preheat and drying method to protect boiler. After the above works are done, corresponding anti-corrosion measures should be taken according to the time of Unit stopping and as per the requirements SD 223-87 in guide rule of stopped/ spare heat equipment anti-corrosion in thermal power plant to protect the unit. 由于是试运机组,启动和停运具有一定的不确定性,以及现场条件的限制,机组应采取氨-联胺法进行停运期间的防锈蚀保护。具体操作方法为:as it is trial run unit and considering there is some uncertainty of starting and stopping and limit of site condition, hydrazine method should be applied to protect unit from corrosion. Here is the operation method. 短期停炉保养:试运期间预计停炉时间在3天以内,当机组停运后,加药泵(磷酸三钠加药泵)继续向炉内加药,逐步调节炉水PH值在10.5—11.0范围,停加药泵,然后关闭所有阀门,将锅炉系统与外界隔离,停止上水、放水,使炉内处于无氧状态,受热面不受腐蚀,从而达到锅炉保养的作用。 Boiler maintenance in short time stop: boiler stop time during trial run is expected within 3 days. When the unit stops, continue dose in boiler with dosing pump (TSP dosing pump) to adjust the PH value of boiler water to 10.5-11.0; then stop dosing and shut off all valves to separate boiler system from outside; stop filling water and discharging to make boiler inside in oxygen free status and keep heat surface from corrosion. In this way, boiler is protected. 长期停炉保养:试运期间预计停炉时间超过20天,在机组停运后,对锅炉进行换水降温,当炉水温度降至70度时,放净炉水,将200m3水箱配制的含联胺浓度大于200mg/l(用氨水调PH值至10~10.5)的氨-联胺溶液,在配药箱内搅拌均匀,用输送泵加到锅炉内,按锅炉上水的要求,将加好药的保护液打入锅炉。直至锅炉顶部所有空气门见水。使炉内保护液面与外界隔离进行保养。保养期间每天做一次取样化学监督,保护掖(N2H4)的浓度大于200mg/l,PH值为10.0-10.5。Long time stop of boiler and maintenance: boiler is expected to stop for more than 20 days during trial run. After unit stops, change boiler water to lower the temperature and discharge boiler water when the temperature reduces to 70℃ and th

文档评论(0)

qwd513620855 + 关注
实名认证
文档贡献者

该用户很懒,什么也没介绍

1亿VIP精品文档

相关文档