金属探测器(METALDETECTOR)指导书(1).docVIP

金属探测器 METAL DETECTOR 使 用 说 明 书 OPERATING INSTRUCTIONS 抚顺市沃尔普机电设备有限公司 FUSHUN WLLP ELECTRIC-MECHANIC EQUIPMENT CO.，LTD. 目 录 contents 1 适用范围Applying ranges 1 2 主要参数Main specifictions 1 3 设备结构 Equipment structure 2 4 使用方法 O perating methods 6 5 注意事项Cautions 7 6 调试步骤Debugging procedures 7 在使用前请仔细阅读本说明书 Please carefully read this instruction before for proper operation 适用范围Applying ranges 本机主要适用于发电厂、造纸厂、水泥厂、矿山等大型胶带输送机上（500mm-2000mm）,160mm以上可按实际皮带机配作。 This equipment mainly apply to the larger transport strap device (500mm-2000mm)on the power plant、paper mill、concrete plant、mines ,etc. if width is larger than 1600mm , may manufacture according to the actual width of transport strap. 主要参数Main specifictions 环境条件 surroundings conditions 温度：-10~60℃ temperature: -10～60℃ 相对湿度：85% RH(40℃); Relative humidity ：85%RH(40℃); 工作电压：～240V 50HZ operating voltage：～240V f=50HZ 功耗：＜35W power consumption：less than 35W 主控制箱体积：27.0×27.0×16.0(cm) main control box dimensions 27.0X37.0X16.0(cm) 主控制箱重量：12kg main control box weight：12Kg 功能指示 function index sensitivity (sheet 1) 灵敏度标准sensitive standard 物料速度material speed 规格specification WJT-5 WJT-6 WJT-8 WJT-10 WJT-12 WJT-14 1～4m/s 样 块 sample piece electrician pure iron φ35mm 控制输出为继电器1常开状态与1常闭状态，并与外接负载相连接control output relay 1 normally open state and a 1 normally closed state, and the external load is connected 安装条件 Installating conditions 传感器安装基础振幅＜0.5mm。 the basic vibrating extent of sensor fitting＜0.5mm。 如果皮带机架振动幅度过大，最好单独做个地基，使振动减小到最低状态。 if the vibrating extent of transport strap frame is over larger, the best way is to fit onto a individual base. Make the vibration reducing to the smallest state 。 传感器与地面安装倾角＜18° Obliquity between sensor and floor ＜18°。 设备结构 Equipment structure 本机由传感器与主控箱两部分组成 This equipment is made up with two parts of sensor and control box 。 传感器外形及规格 Outline and specification of sensor 型号MODEL 尺寸 DIMENSION WJT-5 WJT-6 WJT-8 WJT-10 WJT-12 WJT-14 STRAP WIDTH 带宽 500 650 800 1000 1200 1400