FEC编程培训.ppt

FEC 编程培训 Su Jie FEC编程培训内容 编程方法简介 功能模块介绍 应用举例 编程方法 树状编程 自定义编程 CCT Blocks Reliability Merge and Reliability Check in Boolean Reliability Merge Provides the ability to set the reliability of the value being sent. When the Input is Reliable input is True, the Present Value is set to the current Input with a Reliability of Reliable. When the Input is Reliable input is False, the Present Value is held at its last value with a Reliability of Unreliable. Reliability Check Provides the ability to check reliability of the source value. The Present Value is set to True if the input reliability is Reliable; otherwise the Present Value is False. CCT Blocks MUX and Math Blocks 举例：计算回风湿度与回风湿度设定值之差，并用MUX去选择： 差值 加湿阀开度 20% 0% 20%~50% 50% 50% 100% 注：双击MUX模块，改变输入数量及其他配置。 CCT Blocks Timer Latch The Latch logic block holds a Boolean True value until you command it to reset. Latch blocks help capture rapidly changing binary states that might otherwise be missed. For example, use this block to capture alarm conditions. 举例：水泵状态在30秒内与命令不匹配将产生报警，并且只有报警reset信号才能复位报警。 CCT Blocks Rate Limiter (soft start/ramp) The Rate Limiter logic block controls the rate at which the Output changes with variations in the Input value. If rate limiting is disabled, this block passes the value of the Input to the Output. If rate limiting is enabled, this block limits changes to its Output to an increment determined by the Step Equation. The Rate Limiter block updates every 5?seconds. Step Equation = Rate Limit x 5/60.0 Rate limit = % change/minute (i.e. how fast it ramps) Custom Programming ACTIVITY 举例 锅炉系统启动（BLR-Start）命令发出后,热水泵（HWP-C）开启 当热水泵状态（HWP-S）返回后开启锅炉（BLR-C） 当锅炉停止2分钟后热水泵停止 Custom Programming  Hybrid Activity Creating A New Hybrid Activity Hybrid Activi