bios 刷黑后 用软驱恢复（刷黑后 用软驱恢复 BIOS）.docVIP

bios 刷黑后 用软驱恢复（刷黑后 用软驱恢复 BIOS） AWARD uses the BOOT boot zone to restore BIOS analysis BIOS maintenance site, mouse production Note: This article is copyrighted for all BIOS maintenance sites. Please do not reprint it freely or for other commercial purposes. Upgrade BIOS, you can solve the hardware compatibility or support large hard disk and other issues, so users will be their motherboard BIOS upgrade to the latest version as much as possible. But when we refresh BIOS, we can use Boot Block to restore BIOS because the refresh process stops halfway or the BIOS file is written in error. Boot, that is, Boot Block block, Boot Block block, is a block based BIOS structure, which keeps a region in the BIOS chip, and retains the most important boot information in the BIOS system. The default value of a higher version of the refresh program now is that the Boot Block block of the BIOS is not updated when it is refreshed (Figure 1). With the BIOS version of the BOOT, support for the driver at the same time, in the old motherboard, if the BIOS is damaged, a boot no display, but a floppy disk reading action, then we can use the automatic batch processing method or install ISA card to enter the recovery (at this time, only supports BOOT and floppy drive ISA; two, graphics) with the popularity of the upgrade version of the BIOS and AGP graphics, BOOT support AGP card and floppy drive (at this point, BIOS is damaged, the screen display, as shown in Figure two); the three is not much use now because the floppy drive, in order to facilitate the repair, BOOT began to support the hard disk, you can restore from the hard disk (the boot, screen display, tips from the hard disk recovery, as shown in Figure three) Figure two Figure three When the BIOS refresh fails, when the above prompts appear, we can use the floppy disk and the hard disk for recovery. But there is a problem, our previous approach is to create a startup disk, and then make the autoexec.bat batch file, use this disk to