基于组态王.doc

基于组态王61771 摘 要 本次设计的题目是基于组态王6.5水箱液位前馈反馈控制系统设计。液位的前 馈反馈控制，由反馈和前馈两个控制回路组成。此次设计中以下水箱液位系统为研 究对象，下水箱液位为被控变量，支路1流量为干扰量，通过对支路2流量的控制使 下水箱液位保持恒定。即,当支路1流量增大，液位升高，系统通过前馈和反馈控制 使调节阀的开度减小，从而减少支路2流量，使液位降回到给定值。反之，亦能实 现。本实验主要运用A3000高级过程控制系统，这是一套用于教学研究的复杂性控 制装置。实验中控制器、控制阀、变送器等仪表的选择要合理。本次设计中利用组 态王软件开发了相应的上位监控软件（包括变量的定义、画面的开发、动态连接）， 使实验过程显示更清晰，运行结果更准确明了。 关键词：下水箱液位,控制阀,控制回路,前馈反馈 I 基于组态王 6.5 水箱液位前馈反馈控制系统设计 Abstract This design topic is the design of liquid-level feedforward and feedback control which based on KingView 6.5. The level feedforward and feedback control, is composed of the feedback and the feedforward control loops. This design take the the liquid-level system as the research object. Take the liquid-level as the congtrolling variable, and the first leg current capacity is the disturbance quantity, through causes the second leg current capacity control the liquid-level to be constant. Namely, when the first leg current capacity increases, the level elevates, the system causes the regulating valve through the forward feed and the reaction control to open increases, fall off the second leg current capacity enable the liquid-level to return the given value. Otherwise, it also can realize. Experimental use of the main A3000 advanced process control system, which is a set of teaching and research for the complexity of the control devices. The controller, control valve, transfer and the other meters ’ selection have to be reasonable. In the supervision layer, the HMI is explored by KingView software, including the variable definition and drawing picture and dynamic connection. So that the experiment shows more clearly,