注塑产品模具可行性分析(DFM).pptVIP

Draft Analysis information-Core side Cavity side Core side 后模所有未拔模面建议减胶拔模1°以上 At the Core side， all these surface need reduce plastic make draft angle more then one degree. Part Issue two 客户确认更改 Cavity Lifter Slider Customer comment. (please give your approval and comments) OK or NG remark Approval by: date Notes: please advice any concern on witness line form by lifter. 此处位置倒扣，为简化模具结构和生产稳定，建议修改。Undercut position need to modify 建议修改成这种枕位可以成型的特征（左右两侧）Suggest modify like this (both are the same) Part Issue three PPT乐新更新得更详细， 0.65 此处模具上做枕位封胶太薄，而且此处C角和R角会产生薄钢，建议取消，加宽枕位封胶位置2MM以上 This position