模具精各部件的英文名称.docVIP

This trial version can use only a part of item. Function of Major Parts You will learn about the names and functions of major parts used for an ejection system.A push back pin and a coil spring are used for regular molds, whereas a push back pin and a gas spring are sometimes used for large size molds.This figure illustrates an example of a large mold. Ejector Stopper (Stroke End Pin) A block that stops an ejector plate from going forward [ stop pin] Sprue Lock Pins A pin has the edge of which is undercut to pull a part in mold opening and remove a sprue from a sprue bush.After mold opening, this pin will function as an ejector pin and ejects the sprue from a aprue bush. Also it releases gas contained in molten plastic. Ejector Plate Also called a push plate. A plate that supports an edge of an ejector pin or a push back pin to eject a part from a mold.It is ejected by an ejector device of a molding machine, and returned to the original position when the edge of a push back pin collides with a cavity plate during mold clamping. Stop Pins A stopper installed to keep an ejector plate horizontal or prevent the ejector plate from retreating too far and damaging a core adaptor plate. Ejector Guide Pins / Ejector Guide Bush An ejector guide pin is also called a push plate guide pin and functions as a guide for sliding of an ejector plate.Because an ejector guide bush slides, a hard material is used. An ejector guide bush is also called a push plate guide bush. It is a cylindrical part used to determine the position by matching the ejector guide pin. Push Rods A shaft linked to the force (hydraulic or mechanical) of the molding machine in order to get the ejector plate to work. Gas Spring / Gas Spring Holder A gas spring forcibly pushes back an ejector plate. The strength of the spring is adjusted by adjusting the filling pressure.When using a gas spring, make sure to avoid high temperature (heat may expand gas, deteriorating the original functions of a gas spri