坝体填料的填筑保护及基础流体力学为分析一填料的填筑保护-外文翻译.docxVIP

Hydromechanical analysis of Placing and protecting fillflow behavior in damAbstract:Primary surface according to the design requirements of excavation and stone processing, to ensure that the dense, with certain strength and stability meet the requirements. Quarry mining, transport in the repair of the road at the same time, excavator, bulldozer, with clear reclaimer field covering layer, to ensure that no weed roots and soil tillage. Abandon the material piling up in the yard right as obstinate cultivated material, also prepare slope to prevent soil erosiondam filling should be done: regardless of which part of the fill and the final foundation surface exposure time does not exceed 72 hours. Fill method should also prevent the separation of the filling material. If the contract requirements in different lots of different filling packing and contracting business in construction should prevent of confusion between the different types of fillers.Key words: Hydromechanical fill permeabilityAny undesirable material accumulated on the fill surface shall be removed before placeing the next layer of fill.No fill material shall be placed on a previous layer of that has dried out,become saturated or in any way deteriorated by exposure or by spilling of other material or disterbance by mechanical transport or by deposition of wind blown particles or by any other means. Before fresh fill material is placed aoo such deteriorated fill or foreign material shall be removed to a depth at which material of an acceptable standard is exposed. The surface of each layer is to be approved by the Engineer before the next layer is placed.Any fill shall be placed in uniform layers not greater than the approved thickness as specified hereafter and in an orderly sequence approximately horizontal along the centreline of the embankments.Except where specified of directed otherwise, no portion of any embankment shall be stepped more than 3 feet higher than any immediately adjacent portion except