通信工程专业毕业设计-基于CDMA网络的可动式智能图像采集系统.docVIP

摘要 随着嵌入式电子设备的开发的不断深入和广泛的普及，嵌入式电子设备在我们的日常生活中占有越来越重要的地位。利用嵌入式电子设备作为图像处理的核心，用CDMA无线路由器将处理后的图像数据转移到通信网络上去，这样就可以低成本的实现随时随地监控的梦想。 本设计的主要工作围绕控制终端的硬件设计展开。详细阐述了组成图像模块各个功能单元的硬件电路设计和实现方法，这些单元包括图像采集、图像编码压缩、图像传输。引入S3C44BOX作为控制处理器，对S3C44BOX的最小系统电路设计做了详细介绍，设计了对图像处理模块与CDMA无线通信模块分别实现连接的串口电路，在设计中充分考虑了抗干扰设计。 对CDMA无线通信模块，阐述了CDMA无线通信的工作原理，理论论证的基础上选择了集成化的MG801A作为无线通信模块。 在软件设计中，分析了JPEG编码压缩的原理，针对BF533，在DSP集成开发环境visual dsp++上完成了图像采集压缩的软件设计。描述了控制处理器的各个任务及其工作原理，简要介绍了CDMA无线通信模块的实现方法。 关键词：码分多址无线通信图像采集无线监控 Abstract With the development of embedded electronic devices deepening and broad popularity， embedded electronic devices in our daily lives occupy an increasingly important position. With the embedded electronic device as the core of image processing， re-use of CDMA wireless router to the processed image data transferred to the communications network up， It would thus to cost of achieving the dream of anytime， anywhere monitoring. The paper’s main task revolves the hardware design of the monitoring terminal．It specifically elaborates the hardware circuit design and the realization method of each function unit composing the image gathering module．These units include image gathering，image coding，and image transmission．Monitoring terminal uses S3C44BOX fits its monitoring processor．It gives a detailed introduction of the S3C44BOX smallest system circuit design，and designs a UART circuit to connect the image gathering module and the CDMA wireless connecting module．While the antijamming is fully considered during the whole plan． In the CDMA wireless transmission module part，the paper elaborates the working principle of CDMA wireless connecting，and chooses the integrated MG801A the wireless connecting module founding On the theory proof． In the software design，it analyzes the JPEG code compression principle．And then focusing On BF533．completes the image gathering software design based the integrated development environment VISUAL DSP++of DSP．Then the paper describes each task and the working princip