ABB DCS 培训课程 T315-19 Exercise 19.1 - RevA.docVIP

Create your own Faceplate Goals Make the faceplate for the Function Block Type (TempControl_FBtype) that you created earlier on behalf of the control of the heater and the cooler. Legend Indicates a key name. | Indicates when you go from one menu to a sub-menu. Bold Indicates a menu name or an option in a menu, or file structures “ “ Indicates dialog box buttons, tabs, instructions etc. ( Indicates start/explanation of student activity Exercise Steps This exercise is done in the Engineering Workplace, partly with the Graphics Builder. Create the faceplate Select the Function Block Type TempControl_FBtype in the Object Type Structure Create an aspect of the category Faceplate. Configure the Faceplate according to the following specification: Guidelines to Create the Faceplate To be able to create the set point input field you need to create a Faceplate Element first that will be incorporated in the Faceplate later: In the Faceplate Element insert the following ActiveX Control InputField Use the property PropertyRef and configure it as follows: The Faceplate aspect must be set as the default aspect. Test the Faceplate Test the faceplate by using the command buttons. You can select the faceplate from the Control Structure or via the graphic display for the reactor that you created in a previous exercise. You will experience that the commands that are send to the faceplate are kept to “true”. Actually the code in the Function Block Type should reset these commands to “false”. To check the commands that are send from the faceplate to the object select the Function Block aspect:  Change the Function Block Type TempControl_FBtype as follows by adding a new code block: T315-19 Exercise 19.1 - RevA System 800xA training 2 / 5 1 / 5 T315-19 Exercise 19.1 - RevA 2 / 6 Indication that output is activated MAN or AUT indication Feedback indication 1 = ON 0 = OFF Input field for the set point Command buttons: AUTMAN START STOP