实验一 计算机与交换机基本设置.doc

实验一 计算机和交换机基本设置（交换机3 6 口连接电脑） 添加一个交换机，一个计算机，双击交换机，进入终端配置： Quidwaysystem password: [Quidway]sysname S3026 ;交换机命名 [S3026]super password 111 ;设置特权密码 [S3026]user-interface vty 0 4 [S3026-ui-vty0-4]authentication-mode password [S3026-ui-vty0-4]set authentication-mode password simple 222 [S3026-ui-vty0-4]user privilege level 3 [S3026-ui-vty0-4]quit [S3026]quit S3026sys password:111 [S3026]display currect-config [S3026]dis curr [S3026]vlan 2 [S3026-vlan2]port ethernet0/2 [S3026-vlan2]port e0/4 to et0/6 [S3026-vlan2]quit [S3026]dis vlan [S3026]int e0/3 [S3026-Ethernet1]port access vlan 2 [S3026-Ethernet1]quit [S3026]dis vlan [S3026]dis curr [S3026]interface vlan 1 [S3026-Vlan-interface1]ip address [S3026-Vlan-interface1]quit [S3026]ip route-static [S3026]ip default-gateway [S3026]dis curr [S3026]save 双击小电脑： login:root password:linux [root@PCA root]#ifconfig eth0 netmask [root@PCA root]#ifconfig [root@PCA root]#route add default gw [root@PCA root]#route [root@PCA root]#ping [root@PCA root]#telnet 实验二 配置端口聚合 要求聚合的端口工作在全双工，速度一致，在同一槽口且连续。 参数：ingress:源MAC, both:源和目的MAC 对于SwitchA: [Quidway]sysname SwitchA [SwitchA]interface ethernet0/1 [SwitchA-Ethernet0/1]duplex full [SwitchA-Ethernet0/1]speed 100 [SwitchA-Ethernet0/1]port link-type trunk [SwitchA-Ethernet0/1]port trunk permit vlan all [SwitchA-Ethernet0/1]int e0/2 [SwitchA-Ethernet0/2]duplex full [SwitchA-Ethernet0/2]speed 100 [SwitchA-Ethernet0/2]port link-type trunk [SwitchA-Ethernet0/2]port trunk permit vlan all 对于SwitchB: [Quidway]sysname SwitchB [SwitchB]interface ethernet0/1 [SwitchB-Ethernet0/1]duplex full [SwitchB-Ethernet0/1]speed 100 [SwitchB-Ethernet0/1]port link-type trunk [SwitchB-Ethernet0/1]port trunk permit vlan all [SwitchB-Ethernet0/1]int e0/2 [SwitchB-Ethernet0/2]duplex full [SwitchB-Ethernet0/2]speed 100 [SwitchB-Ethernet0/2]port link-type trunk [SwitchB-Ethernet0/2]port trunk permit vlan all 聚合操作： [SwitchA]link-aggregation ethernet0/1 to ethernet0/2 both