__平板印刷工（__ flat printing industry ）.docVIP

__平板印刷工(2)（__ flat printing industry (2)） 151, no moire in printing dot is () (answer: B). A square dot B FM dot C round dot D chain point 152. Which of the following colors belong to primary colors?. (answer: C) A red B black C magenta D blue 153, in accordance with the industry standards, flat printing fine printing overprinter allowable error is (). (answer: B) A = 0.01mm B = 0.10mm C = 0.20mm D = 0.30mm 154, blanket hardness and plate printing rate and dot transfer related, usually air cushion blanket hardness is about A (Shore) () degrees. (answer: C) A 30~45 B 50~70 C 75~85 D 90~95 155, usually PS version of the fountain liquid pH value of 5~6, conductivity requirements (). (answer: B) A 600~800 B 800~1200 C 1100~1600 D 1600~2000 156, in the offset process for () emulsification is not only inevitable, but also necessary. (answer: B) A B oil in water emulsion C water immiscible oil-water separation D 157. When adjusting or maintaining the offset press, it must be carried out in (). (answer: C) A shutdown, B power off, C in safety insurance state, D cut off gas source 158. The density value of printing quality should be selected (). (answer: B) A just printed density value B ink drying density value C A+B D does not matter 159. The ratio of the film thickness to the ink film thickness is about (). (answer: D) A 2:1 B 1:4 C 3:1 D 1:3 160. The surface tension of the ink (surface tension of the dampening solution). (answer: B) A is greater than B, less than C equals 161 、 offset press roller gear mostly adopts () pressure angle. (answer: C) A 20 degree B 17 degree C 15 degree or 14.5 degree 162. The zero point of the offset press refers to. (answer: A) A transfer gripper begins to transfer the point between the gripper B gripper and the impression roller, and the C paper suction nozzle begins to release the paper The connection point between D impression roller and paper collecting roller 163 、 domestic offset presses mostly adopt () side drawing gauge. (answer: B)