OK佳能I复印机维修代码.docVIP

OK佳能2020I复印机维修代码1 OK Canon 2020I copier maintenance code 1.txt Canon copier maintenance code E000 thermistor (THI) in the ON THI output power after 100 seconds to reach 100 degrees heat heater (H1) insurance (FU2) output SSR E001 DC controller PCB thermistor THI more than 200 SSR DC controller PCB E002 thermistor in THI reached 100 degrees after 100 seconds, did not reach 170 degrees plus heat exchanger reach 170 degrees within 40 seconds after the output did not reach the 175 degree heat insurance DC controller E003 THI output to the main motor preheating after 150 degrees below E010 in THI (M2) in the main motor drive signal is generated, the main motor (DMDEAD) as 1 as a second motor driver PCB E022 DC controller PCB in the choice in the developer after the engagement of CD unit up to 1.6 seconds, the meshing sensor (PS3) for developing 1 developer engagement sensor DC controller PCB was selected in the CD unit, the black developer engagement of up to 1.6 seconds E030 counter (CNT1) as the ON counter, counter The drive letter for the 0 is normal. If the OFF counter, the counter drive signal for 1 is the normal DC controller PCB E202 exposure system (PM1) in motor power ON after 10 seconds of exposure system initial action failed to complete the exposure system original position sensor in the following situations will not display the error code, but the operation all the keys on the panel are locked AE backward movement in 3 seconds was not completed after exposure for 5 seconds, the back action failed to complete the E204 exposure system (PM1) in motor power ON after 10 seconds of exposure system failed to complete the initial action of.DC controller PCB exposure system original position sensor in the exposure within 5 seconds after the forward movement failed to complete E210 the original lens position sensor (PS4) begins to rotate 20 seconds after the lens motor (M3) lens cable to locate the DIRECT position of the copy operation did not complete the.D