RichtmyerMeshkov Instability Results IAG的的结果 IAG RichtmyerMeshkov不稳定性.pptVIP

* Computer Practical: Numerical Gasdynamics Richtmyer-Meshkov Instability Group 6 Comparison of Results with Different Grid Points 2nd Order Roe Naseem Uddin Lucy Gray Richtmyer-Meshkov Instability Introduction Results Conclusions Questions? Richtmyer-Meshkov Instability Introduction: Definition “The Richtmyer-Meshkov instability arises when a shock wave interacts with an interface separating two different fluids.” Theoretically Predicted: Richtmyer 1960 Experimentally observed: Meshkov 1969 Simulation: Good test case for: CFD validation. Investigation into effects of differing parameters on results, e.g, grid size, time step size, flux functions… etc… Richtmyer-Meshkov Instability Introduction: Basic configuration Two fluids initially at rest with differing properties, e.g. different densities Separated by interface with an initial perturbation Normal shock wave ( travelling from top to bottom from Fluid 1 into Fluid 2) From: M. Brouillette, The Richtmyer-Meshkov Instability, Annu. Rev. Fluid Mech. 34, 445-68 (2002) interface shock Richtmyer-Meshkov Instability Introduction: Development Initial configuration Linear growth with time – crests and troughs are symmetric Start of nonlinear evolution – asymmetric spike and bubble development Roll-up of spike Emergence of small-scales and turbulent mixing From: M. Brouillette, The Richtmyer-Meshkov Instability, Annu. Rev. Fluid Mech. 34, 445-68 (2002) Richtmyer-Meshkov Instability Simulation: Euler 2D code MUSCL Technique 2nd Order in space time Temporal evolution spatial reconstruction Eulerian remapping slope limiting (minmod) Richtmyer-Meshkov Instability Results: Computing Time 16 884 sec Intel Pentium single processor 512 MB Ram, 1.6 GHz 11138.5 sec 600 x 396 fine 8.4 1318.98 sec Computing Time: Ratio (fine:coarse) coarse Grid size: 6 2 808 sec CPU time: 4 300 x 198 Richtmyer-Meshkov Instability Structure details – Generated Vortices Coarse grid simulation The vortex structures ar