可勾连透水框架模型的设计.docVIP

题 目 可勾连透水框架模型设计 关 键 词 镶嵌设置 勾连设置 插值 拟合 误差分析 摘 要： 本文主要是在上一阶段问题基础上研究探讨对四面六边透水框群改进，增大结构强度和其改进的合理性，并对改进后的模型的消能减速的效果建立数学模型。 首先，改进后的新透水框架 如图（1），图中包括契合的镶嵌设置（塞子与塞孔）和勾连设置（四棱柱）。根据镶嵌模型以及框架之间互相咬合从而达到稳定，要求伸长的两边分别为圆柱和圆孔棱柱。 然后，要对模型进行分析，首先研究伸长部分的塞子与塞孔的长度对减速效果的影响，其长度即为原不可勾连的四面六边框架间的间隔长度，通过查找数据，进行插值拟合，根据误差情况，得到大致的关系公式。 根据实验数据得到框架间隔长度（塞子、塞孔长度）与减速率的关系如下： = -1.352e-006*^4 + 0.0001425*^3 + -0.004679*^2 + 0.02452* + 1.078 对以上公式用matlab 数学软件求导得到如下函数关系： y=0.0001*^3-0.0094*^2+0.0736*+4.3120 继续对函数求根即可得 的大致值。 图 4 中的两个相互勾连的框架底面即贴河床的面构成了一个新的正三角形。由三角形的基本定理我们可以得出： 勾连设置的长度即为原四面六边框架杆件的长度与镶嵌设置长度和的一半。 改进后的四面六边框架的结构强度，我们可以采用地震反应谱震型组合法（SRSS法） 参赛队号: 2116 所选题目: A 题 Abstract In this paper, the problem on the basis of the previous phase study was to investigate the effect on the Penetrating box group improved, increasing the structural strength and improve the rationality of the improved model of energy dissipation deceleration mathematical model. First, the new and improved permeable framework shown in Figure (1), the figure fit mosaic set (plug and jack) and the collusion between the settings (prism). According to the mosaic model and framework between bite each other so as to achieve stability, elongation on both sides were cylindrical and round prism. Then, to analyze the model, first of elongation part of the plug and jack length of the slowing effect, its length is the length of the interval in the original non-collusion tetrahedron framework by looking data, interpolation intendstogether, according to the error case, the approximate relationship formula. According to the experimental data, the framework of the length of the interval (plug, plug hole length) and deceleration rate relationship is as follows: = -1.352e-006*^4 + 0.0001425*^3 + -0.004679*^2 + 0.02452* + 1.078 Matlab mathematical software derivation follows a function of the above formula: y=0.0001*^3-0.0094*^2+0.0736*+4.3120 Continue to function Root can get a approximate values. Figu