SCRF Input CouplerspptSCRF输入couplersppt.pptVIP

CC2 Input CouplerIntroduction,Installation, Processing Tim Koeth November 16th, 2005 Input Coupler Delivers power that develops gradient Typical Input Coupler Input Coupler Input Coupler Installation Cavity is assembled in Class 10 CR with 80K window and cold bellows. Input Coupler Installation After the cavity was installed in the cryo vessel, we installed the rest of the input coupler. Input Coupler Installation After the vacuum portion was sealed up, a 150C bake performed to remove water. Ramp ~ 6oC/hr Dwell 24 hrs at 150oC P 1e-5mbar Input Coupler Installation Be certain to protect warm ceramic window during bake. Never place heat tape directly on ceramic ! Input Coupler Installation After bake out, finish Wave Guide Hat installation. Input Coupler Processing PMT looking for sparking in vacuum portion Input Coupler Processing PRESENT DESY S/ H WARE THRESHOLDS: Value FS Conv. Value Software Threshold Hardware Threshold e- 5mA ? 10V 0.5 ~ 1 V 5 ~ 6 V PMT 1 LUX ? 10 V 1 ~ 3 V 5 ~ 6 V P.D. ------ ----- 0.2 V Temp Cerm. 70oC 90oC In-Cplr Vac 1~2E-7 mbar 1E-5mbar The spark interlock is NOT reset! One must inspect the copper waveguide and warm ceramic window after such an event. Input Coupler Processing PROCESS CONTROL LOGIC: SOFTWARE LOGIC: After each RF pulse, if e-, PMT, light, vacuum, temperature etc signals are higher than the threshold value the power is decreased by one step, if not then the power is increased by one step. HARDWARE LOGIC: In addition to the software limits used during processing, there are hardware interlocks with greater trip thresholds. The RF is shut off with the “fast switch” when the Hardware Threshold is exceeded. In the event of a Hardware trip: 1. Turn RF off 2. Wait three minutes 3. The conditioning program tries to reset the interlock 4. If reset is successful, RF power setting is set to the minimum (starting) value, and program does fast power increase (10 steps in 10 seconds) to about 90 to