仿真注意事项.docVIP

Simulate 802.11 with ns-2: When simulating 802.11 wireless links, you need to take care of a few?extra factors due to the lossy radio links: Disable ad hoc routing: You probably want to disable ad hoc routing if you only simulate one BSS: set val(rp) DumbAgent ;# ad-hoc routing protocol Otherwise, periodic route adv messages could interfere with your data packets. Establish ARP before simulating Before any data transmissions, the sources and the sinks are required to exchange ARP messages to resolve MAC-IP addresses. This can be a problem for wireless links: if your link is very lossy (e.g. a