西门子贴片机Siplace D系列培训资料2.ppt

Datum Fu?zeile Transport SIPLACE D-series  Contents General Adjustments Option Conveyor width Mapping plates 2.A Einstellungen TSP 201 Switch on the TSP201 of the D2 and D1 machine: The Transport control unit is used on the S27 HM machine and D2/D1 machine. Hardware ID always 04! 2.B Einstellungen TSP 301 Switch on the TSP301: The Transport control unit is used on the HS60, HF/HF3, X-series machine and D4 machine. This settings are active with the Bios 3.04 or higher and application 6.02 or higher. Note: HS60 Hardware ID 5! 3. Transport Options Conveyor options: Fixed conveyor rail , right / left side Dual conveyor, fixed conveyor rail right/left Long Board option Mechanical PCB alignment Single and Dual under floor conveyor (productivity lift) PCB Barcode SMEMA – Siemens adapter box Vacuum tooling for ceramic substrate 3. Transport Options 3. Transport Options 4. Overview Mapping plates Siplace D-Serie Automation and Drives Automation and Drives Datum Fu?zeile Datum Fu?zeile Contents 2.A Adjustments 201 Description: D – machines DIP switch 1 set: single – OFF / dual conveyor ON DIP switch 2 set station type always ON DIP switch 3 was the clamping sensor now always deactivated DIP switch 4 set CAN speed S27 HM 125 kbit/s OFF D-machine 1Mbit/s ON. DIP switch 5 Set CAN Terminator D1 OFF / D2 (S27 HM) ON DIP switch 6 unused 2.B Adjustments 301 Description: D4, D3-machine - The DIP switch 1and 2, set the hardware ID ?5“ for  the conveyor on this machine DIP switch 3 was the clamping sensor active/deactivated (not used) DIP switch 4 to 8 are not used. Description: HF/HF3, X, D3-machine - The DIP switch 1and 2, set the hardware ID ?6“ for  the conveyor on this machine DIP switch 3 was the clamping sensor active/deactivated (not used),  should be always OFF. DIP switch 4 to 8 are not used. 3. Conveyor options 3. Conveyor options Single conveyor Note: For the option ?excess width you