uv led紫外固化系统设计与研究-design and research of uv led ultraviolet curing system.docx

下载文档 降价啦

7
0
约4.91万字
约 63页
2018-06-28 发布于上海
举报
版权申诉
保障服务

uv led紫外固化系统设计与研究-design and research of uv led ultraviolet curing system.docx

1、本文档共63页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

uv led紫外固化系统设计与研究-design and research of uv led ultraviolet curing system

AbstractWith the development of optical communication industry, optoelectronic devices are used more widely, thereby many higher requirements are put forward in the packaging process of optoelectronic devices. UV curing technology is a most widely used radiation curing packaging technology. However, the slow speed of UV curing light sources development leads to the curing effect not improved as expected. The emerging UV LED light sources have many advantages compared to the high- pressure mercury lamp, to some extent improves the efficiency of UV curing. These advantages consist of the long usful life, reducing the cost of frequent replacement of light bulbs, using LED light emitting mode means there are energy consumption only when UV LED is irradiated thus can effectively save energy, and UV LED light sources irradiate the dispensing position directly without output cable can reduce the cable lossed. Although UV LED light sources have much good performance, the radiation area, exposure time and illumination value and other indicators of UV LED curing system in the market can not meet the various requirments in various industrial productions. In this paper, the problem to be solved is to design a UV LED curing system and make it meet production requirments of the company.The core content of this paper includes constant current source driver circuit design and UV LED chip front-end convergent optical system design.Constant current source driver circuit design.In this paper, buck topology circuit form was used. Chip HV9919 was selected as constant current source controller. As the actual application of the UV curing system required set irradiation and extinguishment time, an external timing relay jack was needed to control the current on and off time. The purpose of entire driver circuit design was to make UV LED driver output current value a constant.UV LED chip front-end convergent optical system design.Design method is to use optical simulation software ZEMAX