毕业设计（论文）-电轮椅车设计（全套图纸三维）.docVIP

北京科技大学毕业设计PAGE 第 PAGE I页 共 28 页电动轮椅车设计摘要文中首先分析了国内外各种电动轮椅车的状况，在对比总结各自优缺点的基础上，由于直流电机的额定输出转矩较低，不足以驱动后轮克服地面摩擦阻力传动，根据国内实际情况，提出了一种含有机械传动减速机构的电动轮椅车，基于这种方案，设计了与之相匹配的减速器及其他传动机构，该方案采用直流电机经减速器与链条连接到后轴，以减低输出转速，增大输出转矩。应用现代设计理论及方法、对驱动方式进行分析和再设计，优化车身骨架结构，添加必要的辅助功能装置，利用计算机辅助设计软件构建电动轮椅车及各零部件三维模型，为新型低成本电动轮椅车的设计开发打下了一定基础，提供了一种供参考的驱动方案和骨架结构。 关键词：电动轮椅车；设计；机械系统The design of electric Patient care carAbstract This paper first analyzes the domestic and foreign various Patient care car status, based on comparing the advantages and disadvantages, because the rated output torque DC motor is low, not enough to drive the rear wheel to overcome the ground friction transmission, according to the actual situation, proposed the electric Patient care car with a mechanical reduction gear mechanism, based on this driving scheme, design of the reducer and other transmission mechanism is matched, the DC motor through reducer and the chain is connected to the rear axle, so as to reduce the output rotation speed, increase the output torque. Use the modern mechanical design theory and method, analyze and re-design the drive mode. Optimize the body frame structure. And add some necessary accessibility devices. Use computer aided design software to build a three-dimensional model of the Patient care car and it’s components. This design of the electric Patient care car’s mechanical systems has lay a certain foundation for the new type low-cost electric Patient care car and has given a reference scheme about drive mode and body frame structure. Keywords: Patient care car; design; mechanical system目 录 HYPERLINK \l _Toc31182 摘要 Ⅰ HYPERLINK \l _Toc31182 ABSTRACT ⅡTOC \o 1-3 \h \u HYPERLINK \l _Toc31182 1、引言 PAGEREF _Toc31182 1 HYPERLINK \l _Toc19322 1.1、选题的目的及其研究意义 PAGEREF _Toc19322 1 HYPERLINK \l _Toc4572 1.2、课题相关领域的研究现状和发展趋势 PAGEREF _Toc4572 1 HYPERLINK \l _Toc14063 1.2.1电动轮椅车的现状 PAGEREF _Toc14063 1 HYPERLINK \l _Toc8126 1.2.2电动轮椅车的发展趋势 PAGEREF _Toc8126 2 HYPERLINK \l _Toc23340 1.2.3研究方法 PAGEREF