4-20mA二线制受控正信号发生器设计.docVIP

辽宁科技大学本科生毕业设计 第 PAGE \* MERGEFORMAT III页20mA二线制受控正弦信号发生器设计摘要本设计是基于单片机MSP430和二线制电流型电阻变送器控制的正弦信号发生器。变送器部分的输入为电阻量，输出为电流量；信号发生部分的输入为电流量，输出为正弦信号。其中变送器输入电阻量的变化范围在1000Ω到2000Ω之间，随后通过信号调理和V/I转换，转换为4-20mA的电流输出。再者，通过专用转换芯片RCV420，将电流量转换为电压量送入到MSP430F149单片机中进行AD转换，并做相应的处理，把对应的控制字送入到AD9851中，最后输出相应的正弦波，同时将采集的数据转换成的相对应的电阻值通过数码进行显示。此设计具有精度高，可靠性强，电路简单合理等特点，具有较高的市场价值。关键词：二线制；V/ I转换；MSP430F149；正弦波；数码管显示AbstractThis design is to design a sine signal generator controller which based on single-chip MSP430 and two-wire system current-mode resistance transmitter. The transmitter’ input is resistance quantity, the output is electricity flow, the sine signal generator controller’ input is electricity flow, the output is sine signals. Among them the amount of input resistance transmitter range between 1,000Ω and 2,000Ω, Then through the signal disposal and V/I conversion, and it is converted into 4~20mA, through the RCV420 conversion chip, it can convert the current to voltage which is sent to the MSP430F149 microcontroller to do the AD conversion, and handled accordingly, then take the corresponding control word into the AD9851, finally, outputs the corresponding sine wave. Meanwhile, takes the collected data with the corresponding resistance values displayed by the digital control.This design has high accuracy, reliability, simple circuit, reasonable, low cost, and a high market value.Key words: Two-wire system;V/I conversion;MSP430F149;Sine wave;Digital display目录辽宁科技大学本科生毕业设计 第 PAGE \* MERGEFORMAT 39页 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc295399807 1 绪论 PAGEREF _Toc295399807 \h 1 HYPERLINK \l _Toc295399808 1.1数据采集与传输系统的历史 PAGEREF _Toc295399808 \h 1 HYPERLINK \l _Toc295399809 1.2 国内外数据采集与传输系统的现状 PAGEREF _Toc295399809 \h 1 HYPERLINK \l _Toc295399810 1.2.1 国外数据采集与传输的现况 PAGEREF _Toc295399810 \h 2 HYPERLINK \l _Toc295399811 1.2.2国内数据采集与传输的现况 PAGEREF _Toc295399811 \h 2 HYPERLINK \l _Toc295399812 1.3 发展前景 PAGEREF _Toc295399812