铝质dhaikon门手把系列产品规格.docVIP

DHA-075 Product Specification for the Ikon door handle range in Aluminum 铝质DHA-075 Ikon门手把系列产品规格 Test methods / Pass criteria (测试方法 / 判定标准) The following product test requirements are as specified in section 3,product performance. Methods of testing and pass criteria are defined in reference to BS EN 1906:2002(Building hardware Lever handles and knob furniture-Requirements and test methods). Resultant test results are for internal reference only. No claims of conformance to BS EN 1906:2002 should be made against any or all results obtained. 下列产品测试条件与第3节相同； 产品性能的测试方法和和接收标准依BS EN 1906:2002的定义(建筑五金杠杆式手柄和家具拉手-测试条件和方法)； 综合测验结果仅作内部参考，亦不要求完全按照BS EN 1906:2002进行测试。 4.1 Category of use (应用范围) 4.1.1 Rotational torque strength test (转动扭矩强度测试) A half-set of door furniture is to be mounted into a test block in accordance with EN1906:2002 section 6.2.1.1 The spindle is to be engaged into the aperture of the lever handle to a depth of 15mm. A rotational torque of 30Nm is to applied at a point 50mm?mm from the axis of rotation of the spindle. The torque is to be applied without shock and maintained for 60 seconds and then removed without shock. (See EN 1906:2002 figure B1 for setup details) 按照EN1906:2002第6.2.1.1条款的方法将半套产品安放在测试治具中，　　 使转轴伸入手柄的孔中，伸入深度为15mm。 将一个30Nm的转动扭矩力施加到手柄距转轴50±2mm的部位，无外震干扰匀速施力，持续60秒后无冲击松开。 (详见EN 1906:2002 图B1) Note: Equivalent point load at 50mm radii=61kg An additional test is to be undertaken on a new door furniture sample to establish load and failure mode to break product. 　　注意: 依半径50mm处的施力点负载为61Kg 失效模式测试：取新的样品并依上述方式，增加负荷，直到产品断裂。 Pass Criteria（判定标准）： No failure of any component shall occur and the lever handle shall still operate after test. No permanent deformation greater than 5mm shall occur as measured at 50mm form the axis of rotation. 无任何失效现象发生，而且手柄在测试之后仍然能够操作。 在 50mm方式的扭矩强度测试中没有出现大于5mm的永久性变形。 4.1.2 Axial strength test　（轴向强度测试） A sample set of door furniture are to be mounted into a test block in accordance with EN1906: