会龙山溪谷住宅小区边坡 5 至 7 号剖面段治理工程设计.pdfVIP

会龙山溪谷住宅小区边坡5至7号剖面段治理工程设计 会龙山溪谷住宅小区边坡5至7号剖面段治理工程设计 摘 要 本文是对会龙山 ·溪谷住宅小区边坡 5 至 7 号剖面段进行边坡治理工程设计。该场 地位于益阳市花香路与云树南路交汇处西南角，拟建场地的东边由于平整场地和修建云 树南路形成了约 20～30m 高人工边坡，对坡顶建筑物和云树南路的安全和稳定构成威 胁。 设计根据勘察报告数据，简要介绍了稳定性分析的方法（如janbu 法和 bishop 法） 以及不同情况下滑动面搜索方法（如圆弧搜索法、block 搜索法）的选取，利用相关的 边坡稳定性分析软件确定出控制剖面的最小安全系数和危险滑动带。使用传递系数法对 边坡进行分析，计算出边坡的剩余下滑力，并以此为依据采用预应力锚索加固、挡土墙 支护对拟加固边坡进行治理设计。最后结合边坡防排水原则，对边坡进行防排水设计。 在此次设计的专题中对重力式抗滑挡土墙的应用进行了讨论。 关键词：边坡治理；稳定性分析；预应力锚索；挡土墙 会龙山溪谷住宅小区边坡5至7号剖面段治理工程设计 SLOPESECTION5-7CONTROLENGINEERINGDESIGNIN RESIDENTIALAREAOFHUILONGSHANVALLEY ABSTRACT This paper is the design of the slope sections 5 to 7 control engineering in the residential area of Huilongshan valley. The site is located in southwest corner of Huaxiang Road and South Yunshu Road in Yiyang. The east side of the proposed site formed an artificial slope about 20~30m high due to the site formation and the construction of South Yunshu Road, which may cause a security and stability threat to the buildings both on the slope and along the South Yunshu Road. According to the data from the survey report, this design briefly introduces the method of stability analysis (such as Janbu method and Bishop method) and the choosing of sliding surface search methods (such as arc search method, the selection of block search method) under different conditions, and using Slide software to do the corresponding analysis of the slope. To determine the control section with the minimum stability safety factor and the dangerous sliding zone. The transfer coefficient method is employed to determine the residual sliding force of sliding body, and in light of the residual sliding force, retaining wall and prestressed anchor struc