基于三菱PLC自动门论文 （修复的）.docVIP

摘 要 随着电子技术的发展，可编程逻辑控制器（以下简称PLC）不断更新、发展，PLC控制是自动控制中最常见控制方式之一，自动门就是自动控制应用的一典型例子，由于可编程控制器具有很好的处理自动门的开关控制及良好的稳定性，而且可以很简单的改变控制的方式，因此，自动门的生产商家很多都运用PLC来做门的控制器。目前自动门在日常生活中运用越来越广泛。 本文论述的自动门控制系统主要由以下几部分构成：可编程控制器(PLC)、信号采集装置、变频器、驱动装置、传动装置。可编程控制器选用日本三菱电机公司生产的FX2N-32M小型PLC；信号采集装置选用上海晶园微电子公司YSM100/112、W、SAbstract With the development of electronic technology, programmable controller (hereinafter referred to as PLC) continuously update, develop, PLC control is automatic control of one of the most common control, automatic control automatic door is a typical example, the programmable controller has a good handle automatic door switch control and good stability, but also very simple change in a controlled manner, therefore, the production of automatic doors business to do a lot of doors are used PLC controller. Automatic doors currently used in daily life more widely. This paper discusses the automatic door control system mainly consists of the following components: programmable logic controller (PLC), signal acquisition device, the drive, drive, drive. Japans Mitsubishi Electric PLC use the FX2N-32M produced small PLC; signal acquisition device selection Shanghai Wafer Microelectronics produced microwave sensors; inverter Mitsubishi Electric of Japan produced FR-540 converter; drive motor Co., Ltd. Tianjin safe use of YSM100/112, W, S-phase induction motor, the rated torque is 0.43Nm, rated speed 400r/min; transmission belt to drive the use of door movement. The design for environment requirements are lower. The main working principle of this design is determined by the signal acquisition device and have no one after the switch signals into signals transmitted PLC, PLC based inverter switching signals to control the opening and speed to stop the transformation, driven by the gear door movement. Keywords: PLC, inverters, drives, sensors. 目 录 引 言 在经济飞速发展的中国，高楼耸立的大都市里的大厦、宾馆、酒店、银行、商场、写字楼，自动门已经是随处可见。自动门的工作方式是内外两侧当人走近自动门时，感应到人的存在，给控制器一个开门信号，控制器通过驱动装置将门打开当人通过门之后，再将门关闭。由于在通电后可以实现无人管理以其