江西省某金矿开采方案（毕业设计）.doc

摘 要 本文主要研究江西省某金矿开采方案，任务书的日产量为2000t/d。根据地质资料圈定矿床开采范围为300勘探线至337勘探线之间，标高主要在+180到-200m之间的V1号矿体；确定了下盘斜井开拓方案，优选的采矿方法为浅孔房柱法；通风方式为中央对角抽出式通风；侵蚀基准面+103m以上的水采用平硐自流排水，+103m以下的水采用集中排水，先通过管道排到井底水仓，然后通过中央水泵排到地表；矿山采用8小时三班制，矿山服务年限为9年。 关键词： 下盘斜井开拓；抽出式通风；浅孔房柱法；箕斗提升，集中排水。 ABSTRACT This paper studies a gold mining scheme of jiangxi province, commitments for the daily output of 2000 t/d. According to the geological data mining areas delineated deposits for 300 to 337 exploration exploration line between line, mainly in elevation to + 180-200 m between number V1 orebody; Sure the footwall slope development plan, and to select the mining method for shallow holes room and pillar, the method of Ventilation mode for the diagonal pressure into the type ventilation; + 103 m above erosion datum of using flat adit artesian water drainage, + 103 m below the concentration of water drainage, first through the pipe to the top of the well bottom sump, and then through the central pump row to the surface; Mining the eight hours three shifts, mine service fixed number of year for nine years. Keywords: Footwall slope development; Pressure into the type ventilation; Shallow holes room and pillar, the method of Skip to ascend, concentrated drainage. 目 录 TOC \o 1-2 \h \u HYPERLINK \l _Toc26644 第一章 总论 PAGEREF _Toc26644 1 HYPERLINK \l _Toc12754 1.1矿山概况 PAGEREF _Toc12754 1 HYPERLINK \l _Toc8134 1.2设计依据 PAGEREF _Toc8134 2 HYPERLINK \l _Toc3344 1.3矿山建设主要方案 PAGEREF _Toc3344 2 HYPERLINK \l _Toc5556 1.4存在的问题与建议 PAGEREF _Toc5556 2 HYPERLINK \l _Toc26737 第二章 矿山地质 PAGEREF _Toc26737 4 HYPERLINK \l _Toc20395 2.1矿区地理和气候条件 PAGEREF _Toc20395 4 HYPERLINK \l _Toc19294 2.2矿区地质构造 PAGEREF _Toc19294 5 HYPERLINK \l _Toc5398 2.3V1矿体地质特征 PAGEREF _Toc5398 9 HYPERLINK \l _Toc20136 2.4矿区水文地质 PAGEREF _Toc20136 9 HYPERLINK \l _Toc13871 2.5矿区工程地质 PAGEREF _Toc13871 10 HYPERLINK \l _Toc31120 2.6矿区环境地质 PAGEREF _Toc31120 10 HYPERLINK \l _Toc23931 第三章 矿山年产量及服务年限 PAGEREF _Toc23931 11 HYPERLINK \l