基于STC89C52单片机的温度报警器的设计与制作论文.docVIP

基于STC89C52单片机的温度报警器的设计与制作【毕业论文】 桂林航天工业学院论文 基于STC89C52单片机的温度报警器的设计与制作 Design and production based STC89C52 microcontroller temperature alarm 专 业应用电子技术 学 生陆星球 指导教师 桂林航天工业学院电子工程系 二零壹贰年陆月中文摘要 在日常生活及工农业生产中对温度的检测及控制时常显得极其重要因此对数显温度计的设计有着实际意义和广泛的应用本文介绍一种利用单片机实现对温度智能控制及显示的方案本毕业设计主要研究的是高精度的数字温度计的设计继而实现对对象的测温测温系统主要包括供电电源数字温度传感器的数据采集电路LED显示电路蜂鸣器报警电路继电器控制按键电路单片机主板电路数字温度传感器的数据采集电路与单片机主板电路是整个系统的关键高精度数字温度计的测温过程由数字温度传感器采集所测对象的温度并将温度传输到单片机最终由液晶显示器显示温度值该数显温度计要求测温范围为－55℃～＋125℃精度误差在05℃以内LED数码管直读显示数字式温度计完全可以代替传统的水银温度计可以在家庭中以及工业中都可以应用实用价值很高 关键词 单片机 ABSTRACT In our daily life and industrial and agricultural production the detection and control of the temperature is extremely important Therefore the design of the digital thermometer has practical significance and a wide range of applications This article describes a programmer which use a microcontroller to achieve and display the right temperature by intelligent control This programmer mainly consists by temperature control sensors MCU LED display modules circuit The main aim of this thesis is to design high-precision digital thermometer and then realize the object temperature measurement Temperature measurement system includes power supply data acquisition circuit of digital temperature sensor LED display circuit buzzer alarm circuit keypad circuit board with a microcontroller circuit data acquisition circuit of digital temperature sensor and board with a microcontroller circuit is the key to the whole system The temperature process of high-precision digital thermometer from collecting the temperature of the object by the digital temperature sensor and the temperature transmitted to the microcontroller and ultimately display temperature by the LED The digital thermometer requires the high degree is positive 99 and the low degree is negative 55 the error is less than 01LED can read the number This digital thermometer could replace the traditional mercurial thermometer can be used in family or industrial a