塑料凳模具设计全套图纸.docVIP

摘 要 本课题主要是针对塑料凳的模具设计,通过对塑件进行工艺的分析和比较,最终设计出一副注塑模。该课题从产品结构工艺性，具体模具结构出发，对模具的浇注系统、模具成型部分的结构、顶出系统、冷却系统、注塑机的选择及有关参数的校核、都有详细的设计，同时并简单的编制了模具的加工工艺。通过整个设计过程表明该模具能够达到此塑件所要求的加工工艺。本次设计的主要任务是凳子结构以及注塑模具的设计，也就是设计一副注塑模具来生产塑料凳塑件产品，以实现自动化提高产量。针对塑料盆的具体结构，该模具是直浇口的单分型面注射模具。根据模具结构，采用直导柱，设置较大的脱模斜度以便利于脱模，省去侧抽芯的设计，其优点在于简化机构，使模具使用空间减小，大大降低了模具的制造成本。通过模具设计表明该模具能达到塑料凳的质量和加工工艺要求。 关键词：注射模、模具设计、工艺、结构、成本 Abstract The topic of this design is a plastic stool mould. By analysing and comparing the process of the plastic parts,I design out a pair of injection mold finally. This subject begins from the craft of product structure, specific structure of mould ,focus on pouring system , structure of molding part , ejector system, cooling system, the selection of injection molding machine and related parameters of checking, at the same time completes the compiling of the mould processing technology. This mold can reach the processing technology require of this plastic parts through analysising the whole design process. The main task of this design is the bench structure and injection mould, that is designing a pair of injection mold to produce plastic products and realize automation. This injection mould adopt Sprue gate and single parting surface according to the structure of plastic chair. According to the mould structure,we uses straight guide pin, sets larger draft angle to pulling out mold easily, saves side core-pulling design. Its advantage is that simplifying the mechanism, decreasing the space of mold used, and greatly reducing the mould manufacturing cost. The mold can reach the requirements of the quality of plastic stool and processing technology . Keywords: injection mould, mold design, process, structure, cost 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc327469643 毕业设计（论文）中英文摘要 PAGEREF _Toc327469643 \h I HYPERLINK \l _Toc327469644 目 录 PAGEREF _Toc327469644 \h III HYPERLINK \l _Toc327469645 引 言 PAGEREF _Toc327469645 \h 1 HYPERLINK \l _Toc327469646 第一章 绪论 PAGEREF _Toc327469646 \h 2 HYPERL