毕业论文(设计)-《杠杆零件的机械加工工艺规程和夹具设计》.docVIP

l 摘要 本设计是CA6140车床杠杆零件的加工工艺规程及一些工序的专用夹具设计。CA6140车床杠杆零件的主要加工表面是平面和孔。一般来说，保证平面的加工精度要比保证孔的加工精度容易。因此，本设计遵循先面后孔的原则，并将孔与平面的加工明确划分成粗加工和精加工阶段以保证孔和平面的加工精度。基准的选择以杠杆 QUOTE 45外圆面作为粗基准，以 QUOTE 25孔及其下表面作为精基准。先将底面加工出来，然后作为定位基准，在以底面作为精基准加工孔。整个加工过程选用专用夹具，考虑到零件的结构尺寸简单，加紧方式多采用手动加紧，加紧简单，机构设计简单，且能满足设计要求。 关键词：杠杆零件，加工工艺，夹具，定位，加紧 图A：零件三维效果图 Abstract This paper is to design the craft processes of making the CA6140lever spare parts and some specialized tongs in the process. The CA6140 lever spare part primarily processes the surface and bores. Generally speaking, to guarantee the accuracy of the flat surface process is easier than that of the bore. Therefore, this design follows the principle that surface first and then the bore, and definitely divides the process of flat surface and bore into coarse processes and precise processes to guarantee the bore process. The basic choice is to consider 45 outside circle as rough basis and to consider 25bore and its next surface as precise basis . The bottom is first processed out to be fixed position basis, and process the bore using the bottom as the precise basis. In the whole processes , specialized tongs are used. In consideration of the simple construction size of the spare parts, clipping by hands is adopted. It is simple, and the organization is simple, and can satisfy the design request. Key Words : Lever spare parts, craft process, tongs, fixed position, tight clip 目录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc264958448 摘要 PAGEREF _Toc264958448 \h I HYPERLINK \l _Toc264958449 Abstract PAGEREF _Toc264958449 \h II HYPERLINK \l _Toc264958449 目录 Ⅲ HYPERLINK \l _Toc264958450 第一章 绪论 PAGEREF _Toc264958450 \h 1 HYPERLINK \l _Toc264958451 1.1课题背景及发展趋势 PAGEREF _Toc264958451 \h 1 HYPERLINK \l _Toc264958452 1.2夹具的基本结构及夹具设计的内容 PAGEREF _Toc264958452 \h 1 HYPERLINK \l _Toc264958453 第二章 杠杆加工工艺规程设计 PAGEREF _Toc264958453 \h 3 HYPERLINK \l _Toc264958454 2.1零件的作用 PAGEREF _Toc264958454 \h 3 HYPERLINK \l _Toc264958455 2.2零件的工艺分析 PAGEREF _Toc2649584