besbelle和cms—我们参与的大型粒子物理前沿-Indico@IHEP.PPTVIP

Achievable MoU deliverables( M. Della Negra, Beijing, 10/042003) CMS Muon system: Introduction and status The CMS Muon System BAN Yong, Peking University 2006/12/12 IHEP, Beijing, China Outline: CMS-Muon system: introduction China’s contribution to CMS Muon system Current status CMS Muon system: introduction 3 different technologies: Drift Tube (DT) (barrel), Cathode strip chamber (CSC) (endcap) Resistive Plate Chambers (RPC) (barrel and endcap) CMS Muon system: requirements Muon system: = excellent trigger, identification and reconstruction performance Muon trigger: excellent performance on single and multi-muons events and an unambiguous id of bunch crossing, combining RPC (fast time resolution) and DT, CSC (good spatial resolution) Redundancy in trigger and reconstruction: 2 technologies in whole angular region Good muon momemtum and charge measurement: muon possibly measured twice, in the tracker (inside 4 T field) and in the muon system, in the whole η region and from a few GeV to a TeV. Muon ID: to achieve very high efficiency (95%) up to η =2.4 Robustness: operate well with a strong magnetic field and high radiation and interaction background At LHC: very high collision rate and low cross section for “new physics” very large background rate electrons and muons reconstruction are crucial in physics study… CMS Muon system: layout CMS Muon system contains: 250 DTs, 540 CSCs and 912 RPCs, cover 0 |η| 2.4 Barrel region (0 |η| 1.2 ): ● magnetic field is low and almost uniform, muon rate is about 1 Hz/cm2 (neutron induced background 1-10 Hz/cm2) ● 5 wheels, each divided in 12 sectors with 4 iron gaps. muon station: one DT and two RPS chambers joint together Endcap region (0.9 |η| 2.4 ): ● magnetic field is strong (up to 3.5 T) and not uniform, gamma and neutron induced backgrounds are high ( 1k Hz/cm2) ● both endcap has 3 iron disks, an