【毕业论文】高压输电线路串联电容补偿装置的仿真.docVIP

Ⅱ Ⅰ 昆 明 学 院 2013届毕业论文（设计） 论文（设计）题目 高压输电线路串联电容补偿装置的仿真 姓 名 　　　　 学 号 　　　　 所属院系 　　　　　 专业年级 　　　　　 指导教师 　　　　　　　　　　　　　　　 日 期 　　　　　　　　 摘 要 通过对6台350MVA的发电机由一条单回路600km的输电线路与短路容量为30000MVA的系统相连时对线路进行串联补偿，首先对串联补偿装置的运行、操作、控制分析研究，运用串联电容补偿的工作原理以及串联电容补偿的的应用，仿真并对此高压输电线路串联电容补偿装置的频率、高压输电线路串联电容补偿装置的暂、稳态进行设置与分析。对线路故障进行分析。其次在全面阐述电容器 、MOV、触发间隙 、阻尼电抗器原理的基础上，重点分析研究了外熔丝电容器与内熔丝电容器及其优缺点 ，指出了故障电容器元件对分布电压的影响；分析了MOV、触发间隙、旁路断路器的作用 ，得出串联补偿装置上放电间隙Gap上的电压、MOV上电流和MOV的能量波形。并提出了限制出现在电容器组上的过电压，保护电容器组措施 ，进一步确定对串联补偿装置正确的操作与控制方法 。 关键词 ： 串联电容；补偿 ； 仿真 ； 分析 Abstract Based on the analysis of series compensation circuit By 6 units of 350 mva generator consists of a single loop, 600 km of transmission lines connected to the system short circuit capacity is 30000 mva for, when the first run for the series compensation device, operation, control, analysis and research, using series capacitance compensation principle, and the application of series capacitor compensation, simulation and high frequency of series capacitor compensation device for transmission lines, transmission lines, series capacitor compensation device setup and analysis of transient, steady state. Analyze the line fault. Second in capacitor, MOV, trigger the gap in this paper, based on the principle of damping reactor, the analysis and research is mainly focused on the fuse outside internal fuse capacitors and capacitor and its advantages and disadvantages, pointed out the influence of fault capacitor element for distributed voltage; Analyzes the MOV, trigger interval, the action of the bypass circuit breaker, draw a series compensation device on the discharge Gap Gap on voltage, MOV on current and the energy of the MOV waveform. And put forward the limit on capacitor group overvoltage, protect the capacitor set of measures, further to the operation of the series compensation device correctly a