变速箱齿轮齿廓修形及其噪音振动特性研究-机械制造及其自动化专业论文.docxVIP

中北大学学位论文 万方数据 传动过程中微小位移这个振动量进行时间序列模型的建立：分别对修形前后的两对齿轮 振动位移进行建模。然后通过 MATLAB 绘制相应的时域图和时间序列模型预测曲线图。 验证非线性时间序列在预测齿轮传动不稳定和故障上的可行性。并比较这两对齿轮啮合 过程中微小位移并且分析原因。并在同样条件下做出一对斜齿轮的时域图和预测曲线 图，对比直齿轮和斜齿轮在运行稳定性上的差别并阐述原因。 关键词：特征信号采集，齿轮齿廓修形，Butterworth 数字滤波器，快速傅里叶变换， GNAR，时间序列 III  Research on transmission gear tooth profile modification and noise vibration characteristics Abstract The gearbox is one of the most important components of the vehicle power system. As a middle power transmission link, it plays a key role in adjusting vehicle speed and torque, so the stable working condition is very important. With the progress of society, People raised higher and higher requirements for passenger cars. A fast, comfortable and quiet driving experience is popular. As an important part of the gear transmission, the gear determines the smooth functioning of the transmission quality and functionality. This article began writing from involutes gear tooth profile modification. Discuss that how to achieve the purpose of reducing vibration and noise through the gear tooth profile modification; The noise reduce that the gear after repair is proved by time-frequency analysis method and the sound features of gear transmission mechanism which in different speed is analysis out by frequency spectrum; Finally, the time-series methods was applied to the surveillance of the gear lifetime and eliminate hidden dangers before gear failure.The noise in the process of the gear teeth meshing is caused by vibration. The vibration model of gear and gear vibration was established. In the involutes gear tooth profile curve, the vibration was taken into account, and coupled a gear tooth profile on the top of the teeth and the root part of the tooth profile modification curve. In order to reduce the gear meshing and the meshing impact strike, vibration and noise reduction of running gear effect. This device and method for detecting, the modern characteristics of signal acquisition were illustrated. The modification of