毕业论文设计《2DS(Y)-106型电动往复泵设计（传动部分）》.docVIP

PAGE PAGE l 毕业设计说明书 毕业生姓名 ： 专业 ： 机械设计制造及其自动化 学号 ： 指导教师 所属系（部） ： 机械电子工程系 年五月 PAGE i EBZ100E掘进机行走部设计 摘 要 本次毕业设计以EBZ100E掘进机行走部为设计对象，主要设计任务有三项：第一项是进行行走减速器的设计，第二项是履带的设计及计算，第三项是掘进机液压系统的分析及部分主要液压元件的计算。 在对行走减速器的设计中，主要考虑减速器所要求的减速比大而紧凑的情况，这有助于减小掘进机行走部的体积，因此查阅掘进机资料及各种减速器的特点，选用一级直齿，二级行星。在减速器设计过程中，首先计算出总传动比，然后进行合理分配，其次计算出各个轴的转速和转矩，在设计过程中确定出各轴的材料和其他参数，最后进行校核。 履带的设计主要根据机重，先用经验公式进行各个部件的计算，所得数据再根据同型号掘进机参数进行比较，最后调整，得出一个比较合理的结果，并根据此前的结果验算出履带的接地比压等。 液压系统的分析，主要是参考各种掘进机液压图，并仔细研究分析各个回路的油路并对主要液压元件进行设计和校验。 关键词：掘进机；履带；行星轮减速器；液压回路；液压马达。 Walking EBZ100E boring machine design Abstract  The graduation EBZ100E boring machine designed to run the Department for the design of objects, there are three main design task: the first is the design of running gear reducer, the second is to track the design and calculation, the third is boring machine hydraulic system The main part of the analysis and calculation of hydraulic components. Walking in the design of speed reducer, the main considerations of the speed reducer required than the case of large and compact, which helps reduce operating boring machine the size of the Department, so access to information and a variety of boring machine characteristics reducer, Selection of a straight-tooth, secondary planet. The design process in the reducer, the first calculated the total transmission ratio, and then proceed to a rational allocation, followed by each axis calculate the speed and torque, during the design process to determine the axis of the material and other parameters, the final check. The design of track primarily on the basis of weight machines, use empirical formula for the calculation of the various components, the data re-boring machine in accordance with the model parameters compared to the final adjustment, to arrive at a more reasonable result, and in accordance with the results of the previous check of the track ground pressure and so on. Analysis of the hydraulic system, primarily in the light of a variety