ASTME96-E96M-16 英文版标准文件.pdf

Designation: E96/E96M − 16 Standard Test Methods for Water Vapor Transmission of Materials1 This standard is issued under the fixed designation E96/E96M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (´) indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the U.S. Department of Defense. 1. Scope C1809 Practice for Preparation of Specimens and Reporting 1.1 These test methods cover the determination of water of Results for Permeance Testing of Pressure Sensitive vapor transmission (WVT) of materials through which the Adhesive Sealed Joints in Insulation Vapor Retarders passage of water vapor may be of importance, such as paper, D449/D449M Specification for Asphalt Used in Dampproof- plastic films, other sheet materials, fiberboards, gypsum and ing and Waterproofing plaster products, wood products, and plastics. The test methods D2301 Specification for Vinyl Chloride Plastic Pressure- 1 Sensitive Electrical Insulating Tape are limited to specimens not over 1 ⁄ 4 in. [32 mm] in thickness E177 Practice for Use of the Terms Precision and Bias in except as provided in Section 9. Two basic methods, the